Clamp+Go TM Dolly Handle0 pages
Model 24
TM
Dolly Handle
The Specialist In Drum Handling Equipment
Click Here to Watch the Video
•t
Ergonomic tool to move
drum dollies
•t
Clamps onto various dollies
•t
Drum is far more stable
because force is applied
below the center of gravity
•t
Reduces risks to workers
•t
Helps prevent accidents
•t
Patented Design
TM
MADE
IN
USA
Helps You Prevent Accidents !
Someone left a dock leveler slightly raised, and. . .
New Clamp+Go Dolly Handle (Patented Design)
TM
Model 24
Reduce risks to workers with the ergonomic and safety conscious Morse
Clamp+Go TM Dolly Handle. Attach Clamp+Go TM to the sidewall of your drum
dolly with a downward push to engage the quick-coupling mechanism. Then
pull or push to move your drum around. Easily move into and out of confined
areas.
Increase worker safety by moving drum dollies with the Clamp+Go TM. Don’t
risk catching your fingers between the drum and other objects. Your drum
is far more stable because you apply even force below the drum’s center
of gravity.
For safety reasons, use caution to maintain control and avoid tipping when
pushing at the top of your drum to move a drum dolly. Lateral force at the top
of the drum shifts over 70% of the weight to the front dolly wheels. This can
make the dolly difficult to control, and potentially hazardous without warning
- even topple over, especially if the dolly wheels hit an obstruction, a hole in
the floor, or while descending a slope.
Decrease the risk of this happening by attaching the Clamp+Go to the
drum dolly. You then pull from the bottom of the drum to move it around,
with weight far more evenly distributed on all dolly wheels. You have greater
control, and significantly reduce risk of tipping.
. . .but it’s no problem for the Clamp+Go !
TM
TM
The Clamp+Go TM can be used with round drum
dollies of various sizes. Move the quick-pin to
adjust for 2”, 2.5” or 3” (5.08, 6.35 or 7.62 cm)
tall dolly sidewall. Clamp+Go TM works with all
Morse round drum dollies, and with many other
brands.
Use your steel-toe boot to disengage Clamp+Go
TM
from your dolly. . . then quickly connect to
another. Always comply with the maximum
capacity of the drum dolly being handled.
For convenient storage, push the Clamp+Go TM
handle to upright position, and a magnet holds
it in place.
MORSE Mfg. Co., Inc.
Phone: (315) 437-8475
•
•
727 West Manlius St.
•
P.O. Box 518
Fax: (315) 437-1029
•
Email: info@MorseDrum.com
Copyright 2014 - Morse Mfg. Co., Inc.ttt
Spec Sheet F24t
•
•
East Syracuse, NY 13057-0518
Website: MorseDrum.com
(Updated February 7, 2014 3:07 PM)t
1
"