Series MPD-F113-V - 110W Industrial DC-DC Converter0 pages
Series MPD-F113-V
110W PFC INDUSTRIAL DC/DC CONVERTER
FEATURES
110W
l isolated DC/DC converter with 11.7 CFM
forced air-cooling, 90W convection cooled
Fully
l isolated primary to secondary;
Primary to earth ground
Wide
l DC input range 30-120VDC
Design to meet EN 50155
l
Input
l polarity reversed protection
Compact size 2 x 5 inch
l
Low
linrush current to prevent power adapter
turn on issue
High
l efficiency up to 90%
RoHS
l compliant / CE Compliant
DESCRIPTION
The MPD-F113-V is a compact 5x2 DC/DC PSU offering
Over Voltage Protection: If for some reason the PSU fails to
110W from a wide range input. This device has full primary
control itself, the build-in over voltage protection circuit will shut
to secondary and primary to ground isolation. An additional
down the outputs to prevent damaging external circuits.
feature is the input reverse polarity protection.
The trigger point is from 12.8V to 15V.
Input Reverse Polarity Protection:
Incorrect input polarity does not damage the PSU.
There will be no output voltage in this case.
Hi-Pot: 1.5K VAC, Primary to secondary
SPECIFICATION
Storage Temperature: Min. -20 / Max. +75°C
Input Voltage: 30 ~ 120VDC; Continuous input range
Relative Humidity: Min. 10 / Max. 90% RH, Non-condensing
Min. 28/Max. 140VDC, Endured max. 1sec. for input voltage
Altitude: 2K meter, Operating
dips
Operating Temperature: Derate linearly above 50°C by 0.6%
Input Current: 5A, Nominal DC input voltage, rated load
per °C to a maximum temperature of 70°C
Inrush Current: 10A, Nominal DC input voltage, rated load
At 100% Load: Min. -10°C / Max. +50°C
cold start at 25°C
At 88% Load: Min. -10°C / Max. +70°C
Efficiency: Nom. 90%, Nominal DC input range, rated load
Warranty: 12 months
Ripple & Noise: Rated load, 20MHz bandwidth
Line Regulation: Less than +/- 1% at rated load with +/-10%
changing in nominal DC input voltage
Load Regulation: Measured from 60% to 100% rated load and
from 60% to 20% rated load (60%+/-40% rated load) for each
output, and others voltage setting at 60% circuit.
Automatic recovery upon of overload condition.
Short Circuit or Over Load Protection: The PSU will go into
hiccup mode against short circuit or over load conditions and
will auto-recovery while fault conditions moved.
www.hitekpower.com
"