eFLTE10000 pages

fluid technology
pressure sensors 1000
design

Ø38 x 108mm
Ø38 x 122mm

DW34 G1/2"A
DW35 G1/4"A
DW36 G1/8"

pressure range
pressure range
pressure range

-1 to +600bar
-1 to +600bar
-1 to +1bar

flush-mounted membrane
pressure ranges between -1 and +600bar
data logging function
analog output with adjustable start and
end point
on/off delay seperately adjustable
test function - simulation of the adjusted
switching functions in a pressure-free state
peak hold function for the display
automatic self-test: overload, wire breakage,
and sensor function

intelligent pressure sensor
membrane keyboard, USB interface

description
ipf electronic’s pressure sensors offer a high level of operating comfort.
The DW34 series has a 1/2 inch connection with a flushmounted membrane and can be used for pressures up to
600bar. The media touching parts of the sensor are made
of stainless steel.
The DW35 is differed from an other sensing element connection. It comes with a 1/4 inch connection with an outside thread and can also be used up to +600bar. Like the
DW34 series the media touching parts of the DW35 are also
made of stainless steel.
The DW36 pressure sensor is suitable for low and negative
pressure measurements. This sensor has a 1/8 inch connection. Its pressure sensing element is made of ceramic
and is used in a range of –1 bar to +1 bar.
All devices with a 4-pin connection have 2 outputs.
Although output 1 relates to a freely-programmable switching output, for output 2 a selection can be made between
an analog output, a switching output or an alarm output.
Devices with a 8-pin connection have both 2 switching outputs and an analog output available.
Among other things, the switching points, release positions,
ipf electronic gmbh

Kalver Straße 27
D-58515 Lüdenscheid

output logic and time delay can be programmed via the
membrane keyboard.
For dynamic measurements, the display and the analog output are equipped with an adjustable damping action.
Following installation, the sensor body can be rotated by
350° and the sensor display can be rotated by 180° by
means of the software.
The pressure sensors have an optical interface with which,
in addition, all adjustment parameters can be adjusted and
changed via a PC or notebook.
The test function offers a simple and quick possibility to
check the function of the device and/or the analyses which
have been switched on. In connection with this, each pressure value of the pressure range can be “simulated”
through the operating buttons or by operating the PC. The
device behaves as if the actual pressure were available.

application examples
pressure monitoring for hydraulic aggregates
vacuum checking for vacuum lifters
compressor controls

Fon +49 (0) 2351 / 9365-0
Fax +49 (0) 2351 / 936519

www.ipf-electronic.com
E-Mail: info@ipf-electronic.com

Subject to alteration!
Version: April 2010

1