DM3-i Drying Monitor0 pages

TPDX030-0712
DRYING QUALITY CONTROL
MODEL DM3-i, DRYING MONITOR
ASSURE PROPER
DRYING; DEFECTFREE PRODUCT &
ENERGY SAVINGS
Conair extends the legacy of the patented Drying Monitor with the
introduction of the DM3-i. Drying performance analysis occurs inside
the drying hopper providing you with early detection of poor drying
conditions and allowing you to correct potential issues before you
have processed improperly dried material. With the DM3-i you will
have control of polymer drying, make defect-free parts, save energy
and increase your profitability.
Now available as an independent touch panel, the DM3-i model can
monitor up to 30 hoppers – even non-Conair hoppers. The DM3 is
also available as a dryer option, embedded into the dryer control.
Contact Conair for more information on the DM3-e.
Model DM3-i
MONITOR DRYING FROM WITHIN THE HOPPER
The Drying Monitor consists of a unique, sixzone, stainless steel temperature probe installed
in the drying hopper that senses the specific
temperature profile required for proper drying of
your particular material. Interpretation of that
temperature profile from the DM3-i monitor
leads directly to predicting under or over-dried
material, inadequate air flow, clogged filters,
heater failure, excess throughput, unresponsive
loading, over-capacity drying and many other
conditions that are likely to produce scrap and
waste time, energy and material. In addition,
DM3-i provides information for hopper temperature trending, energy reduction and other data
logging all in one display. It’s web-enabled too,
so you can get that information on the go.
The DM3-i temperature profiles are your visual
assurance and recorded proof that your resins
have been held at supplier’s required drying
temperatures for the required drying time.
Trend data for all monitored hoppers is retrievable for up to seven days and may be exported
directly to a spreadsheet of actual resin residence times and temperatures.
n
Don’t waste time, energy or material
The DM3 monitors the temperature profile inside the drying hopper.
n
Early warnings, early detection of problems
Any out-of-spec temperature zone reading that may lead to incorrectly dried material is shown for immediate correction.
n
Fits any brand hopper
Any size hopper, of any brand may be easily fitted with a Drying
Monitor Probe to report on the state of your drying process, at any
time.
The model DM3-i can monitor up to
30 hoppers for proper drying performance.