M50 pages
Ultra-Fast Miniature Pressure Transducer
Series M5
bandwidth 50 khz / resistant up to 200 °c
The piezoresistive pressure transducers Series M5 are ideal, thanks to the M5 fine thread, for
taking measurements at close proximity in places where access is a problem and in very thin
pipes – exactly the kinds of conditions associated with engine test benches. The front-flush
design prevents gas bubbles interfering with fluid measurements and supports measurements
up to 200 °C without a cooling adapter. The extreme dynamic range of 0…50 kHz makes it
possible to record very fast pulsations just as reliably as those associated with static pressure
values. A vibration-resistant Teflon FEP cable (IP67) ensures the 80 mV output signal is routed
securely out of the hot environment and then onwards for processing.
Sensor technology
The Series M5 sensor incorporates a stable silicon sensor which is backside-soldered directly
to a supporting element designed for excellent fluid dynamics. This construction eliminates the
disadvantages of sealants, adhesives, separating membranes or capillary tubes in high temperature environments. The practically-flush connection to the measurement media is critical
to the excellent dynamic range of 0…50 kHz. The micromechanical design delivers absolute
measuring ranges of 3, 10 and 30 bar, overpressure protection of up to 5 times measuring range
and effective isolation of mounting forces, and a very low dead volume.
Conditions of use
Thanks to the materials used in the pressure connection (silicon oxide, stainless steel, and
gold), the pressure transducers in the M5 series offer excellent media compatibility. They are
designed for operating temperatures between -50 °C and +180 °C and come with a typical output signal range of 80 mV (based on a 1 mA supply) and an individual calibration certificate. The
unit which incorporates a remote measurement amplifier is known as the Series M5 HB (see the
data sheet) and can achieve a total error band of ± 1 %FS for the operating temperature range.
Performance characteristics
• Sensor head capable of exposure to 200 °C
• Broad compensated temperature range, with a choice of either -20…125 °C or -40…180 °C
• Excellent dynamic response, up to 50 kHz (pulsation measurements)
• Insensitive to structure-borne vibration
• Extremely compact design, pressure connection: M5 x 0,5 fine thread
• Teflon FEP cable with IP67 ferrule, suitable for use on test benches
• Pressure ranges of 3 bar, 10 bar and 30 bar (absolute)
ELECTRICAL CONNECTIONS
R2
1,5 m
R1
+IN / TOB (black)
+OUT (red)
Measurement Bridge
-OUT (blue)
-IN (white)
1:1
Shield (wire mesh)
Comments
-t The R1 or R2 resistor provides pre-compensation for the zero-point variation
t with temperature. The recommended value can be found in the calibration sheet.
-t The shield is not connected to the pressure transducer housing.
-t Recommended tightening torque 1,5…2,5 Nm
Subject to change without notice
KELLER AG für Druckmesstechnikt
KELLER Ges. für Druckmesstechnik mbHt
Company certified to ISO 9001
06/2014
St. Gallerstrasse 119t
Schwarzwaldstrasse 17t
CH-8404 Winterthurt
D-79798 Jestettent
Tel. +41 (0)52 - 235 25 25t
Tel. +49 (0)7745 - 9214 - 0t
Fax +41 (0)52 - 235 25 00
Fax +49 (0)7745 - 9214 - 60
www.keller-druck.com