Series 35 X HT(T)0 pages
PRESSURE TRANSMITTER FOR BIO-REACTORS
SERIES 35 X HT
SERIES 35 X HTT
DIGITALLY COMPENSATED / RANGEABLE / DIGITAL AND ANALOG OUTPUT
Piezoresistive pressure transmitter for applications in bio-reactors or autoclaves. The transmitter is compensated up to 150 °C and may be operated continuously or sterilised at this
level, including the special circuit electronics.
The transmitters are supplied in absolute or gauge versions, with current or voltage output.
The sensing component is a micro-machined silicon pressure chip of high sensitivity. An
independent temperature sensor is integrated on the surface of the silicon chip.
Digital Output of Transmitter
Series 35 X HT
These Series are based on the stable, piezoresisitive transducer and a micro-processor
electronics with integrated 16 bit A/D converter. Temperature dependencies and non-linearities
of the sensor are mathematically compensated. With the READ30 software and the KELLER
cable K-107, the calculated pressure can be displayed on a Palmtop, Laptop or PC. The
READ30 software also allows the recording of pressure signals and the graphic display on the
PC. Up to 128 transmitters can be hooked together to a Bus-system.
Transmitter with Analog Output
The micro-processor integrates a D/A converter of 16 bit for analog signal outputs of 4…20 mA
or 0…10 V. The output rate is 100 Hz (adjustable). The accuracy is diminished by this converting process by 0,05 %FS. The digital output is available on all transmitters with analog output.
Programming
With the KELLER software READ30 and PROG 30, a RS485 converter (i.e. K-102, K-104 or
K-107 from KELLER) and a PC, the pressure can be displayed, the units changed, a new gain
Series 35 X HTT
or zero set. The analog output can be set to any range within the compensated range.
PIN ASSIGNMENT
10
Binder
723
MIL
C-26482
OUT / GND
1
C
+Vcc
3
A
0…10V
GND
1
C
3 Wire
OUT
2
B
+Vcc
3
A
RS485A
4
D
RS485B
5
F
Output
4…20mA
2 Wire
ø 21
max. 100
ø 22
80
Digital
ø 19
ø 24
Function
6.5
9
12
HEX 27
G 1/2"
14
2
ø 18.95
ø 18
Series 35 X HT
Series 35 X HTT
(Manometer Pressure Port)
(G 1/2”)
Subject to alterations
KELLER AG für Druckmesstechnik
KELLER Gesellschaft für Druckmesstechnik mbH
Companies approved to ISO 9001 / EN 29001
St. Gallerstrasse 119
Schwarzwaldstrasse 17
CH-8404 Winterthur
D-79798 Jestetten
08/04
Tel. 052 - 235 25 25
Tel. 07745 - 9214 - 0
Fax 052 - 235 25 00
Fax 07745 - 9214 - 50
www.keller-druck.com