BRAZE MATE Model 2000 pages

Brazing & Soldering
BRAZE MATE Model 200
Dual Station Brazing/Soldering Machine
SEQUENCE OF OPERATION:
!
!
!
!
Operator loads assembly into stainless steel
fixtures.
Operator applies paste with automatic dispenser
gun.
Dual "touch" buttons actuate automatic
heating/cooling cycle.
Joined assembly unloaded by operator; rates up to
120/hr.
SPECIFICATIONS
CONSTRUCTION: Structural aluminum frame with
clear acrylic guarding on three sides.
DIMENSIONS: 72"W x 56"D x 34" load height;
operator can be seated.
PASTE APPLICATOR: Three modes available: 1)
Fully automatic, slide mounted, in-station. 2) Semiautomatic, fixed position, off-station. 3) Hand held,
automatic, in-station.
HEATING: Rigid steel gas train includes air pressure
switch, gas flow meter, and manifold pressure
gauges.Dual heat stations have independent slides and
controls so different assemblies can be brazed or
soldered simultaneously. Hi-Lo flame control to
conserve fuel when heat manifolds are retracted and
idle. Burners oscillate horizontally to provide even
heating (independent from side to side)
COOLING: Timed air and water sequence; water
captured in stainless steel trough; optional water
recirculating system available. (Optional Water
Recirculating System includes air driven pump with
solid waste filter and cartridge flux filter.)
Dual heat stations
feature independent
control and hi-lo
flame to conserve fuel.
Oscillating
burners
eliminate
"hot spots"
during
heating cycle.
FIXTURES: Mounted on stainless steel "unistrut".
Quotations based on assembly prints and parts.
CONTROL: PLC with Operator Interface Panel to
change timers and counters.
UTILITIES: 120 volts, single phase, 5 amp; natural
gas or propane; 80 psi air, water and drain.
FUSION INCORPORATED
4658 E. 355th St., Willoughby, OH 44094
Phone 1-800-626-9501 o (440) 946-3300
Fax (440) 942-9083 o e-mail: sales@fusion