Level switch RAPID LEVEL RLG2 with 2 floats0 pages

RL/G2

LEVEL SWITCH
WITH 2 FLOATS

LEVEL

Rapid Level - Level switch with 2 floats
- The required length can be obtained simply by cutting the steel rod,
using an ordinary pipe cutter; or the switching point can be varied by
using a float with through hole allowing the required liquid control point
to be modified whenever necessary.
- It can be used for dirty liquids, water, petroleum, cutting oils, and tolerates the presence of metal and ferrous particles, since the float does not
hold a magnet and is integral with the rod.
- One float can operate just one Reed (min. or max. level), or two Reeds
(min. and empty and extra max. level) thus meeting the most complex
needs.

Tutti i dati ed i contenuti di questa scheda sono di proprietà esclusiva di Riels Instruments

- Total safety since the electrical part is completely separate in the tank
side and perfectly sealed with respect to the external side by means of
ultrasonic welding and resin coating of the pins.
- The nylon-glass body is very strong and very resistant with respect to
chemicals, and is ideal as an insulating container for the Reed contacts.
- The Rapid Levels come standard with rods suitable for control of a max.
measurement of 500 or 1000mm. To obtain specific measurements, refer
to the table on the next page.
- They can be ordered already arranged for the control of predetermined
measurements.
-The RL/G2 range has a head which holds two control rods and two
floats.
- Each control rod can commutate the signal of 1 or 2 Reeds (with single
or exchange contact). Each head can therefore contain from 2 to 4 Reeds.
- The most suitable system can chosen for each rod.
- In case of excessively dense liquids the two floats can be supplied entirely separate from each other to prevent rod 1 from undergoing friction
with the float of rod 2.
- The minimum distance between the two points to be controlled is
90mm.

Fixing diagram
Connection:

Through Float
On request the float can be supplied
with through hole and therefore be
positioned in the required position
without having to cut the rod (which
can therefore be as long as the height
of the tank). If necessary, the liquid
control point can be subsequently be
modified as required by simply moving
the float.

Riels Instruments Srl

CONNECTOR CE DIN 43650 IP65
PG.9

+39 049 8961771

IP65 CONNECTION HEAD WITH
6 POLARITIES
Indispensable for use with systems
providing for 4 to 6 polarities.

+39 049 717368 www.riels.it info@riels.it