Operation manusal S0 pages

Thank you for purchasing the Pulsarlube S, the new and unique spring type single-point grease dispenser from
Pulsarlube USA, Inc. The Pulsarlube S is a refillable lubricator.
To ensure the safe operation and proper installation of the Pulsarlube S unit, we strongly recommend that you
read the following information carefully before use. If you require further information, please contact your local
supplier.
‡@ Make sure the valve position indicator located at top of dispenser is set to “OFF”
‡A Turn and pull out the piston locking hinges found at the bottom of the lubricator.
‡B Turn the valve position indicator to #5 to make sure lubricator is dispensing properly,
and then turn to “OFF” position.
‡C Install lubricator on lube point manually and set it to desired dispensing rate from (1~5).
If the Pulsarlube S is already filled ;
Operating Principles
Specifications
Installation Instructions
S Doc No : 3210 REV . 010809
Pulsarlube S (KLT1500)
‡@ Set Control knob to the # 5 position
‡A Remove Red grease nipple cap and fill lubricator with grease gun until grease exits outlet via the center
sleeve of lubricator.
‡B Set Control Knob to “OFF” position and fill lubricator until the piston ring reaches level indicator line
that reads “Do not fill below this line”
‡C Place Red Nipple cap back on the grease point for protection.
‡D Install lubricator on lube point manually and set it to desired dispensing rate from (1~5)
If the Pulsarlube S is not pre-filled ;
¤ýPlease avoid over filling. Overfilling may damage the lubricator.
¤ýPlease use manual grease gun. Do not refill with high pressure, high volume air/electrically
operated grease gun, this may damage the Pulsarlube S unit and warranty will be null and void.
¤ýThe Pulsarlube S is not a “time” programmable unit. The flow control valve is simply to allow you
Warning much more control over the dispensing rate.
Specifications Description Image
Grease Capacity
Normal operating pressure
Operating temp range
Outlet thread size
Weight
Product dimensions
Water Proof
NLGI Range
Remote installation
1/4" (NPT and BSP) Functions on both NPT & BSP lube points
containing a 8mm(1/4") O.D due to
re-enforced composite plastic tip on the lubricator.
100cc
1.3 kgf/ (15 psi)
-23¢ªC ~ 121¢ªC (-10¢ªF ~ 250¢ªF )
Filled : 320g(11.3oz) / Empty : 200g(7oz)
Height : 129mm (5")‚˜Diameter : 67mm(2.6")
Can be used under water.
NLGI 1,2
Can be remotely installed up to 0.3m(1ft ) using a 8mm(1/4") tube
1 2 3