عضویت 
ورود اعضا
راهنمای خرید
FMP(G) - Dual discharge industrial air coolers0 pages
General information & application
Fincoil FMP air coolers and FMPG liquid circulated air coolers
have been designed for cold rooms where a low profile dual
discharge air cooler is required. Suitable for a wide range of
applications with a special focus on meat storage, agricultural
produce and processing rooms. Units are also suitable for
cooling engine rooms and monitoring rooms
Refrigerants all H(C)FC, CO2, brine (G)
Capacities (SC2) 3 up to 73 kW
Air volume 2,520 up to 36,360 m3/h.
Standard configuration
• Finned coil CA
- Cu tubing ø 12.7 mm
- Tube pitch 35 x 30.31 mm staggered
- Corrugated, non-louvered Alu-fins
- Fin spacings 4, 7 or 12 mm.
• 1-4 Fans, available in a range of different executions.
Standard blow-through execution. Fan diameters Ø 450,
500 and 630 mm.
All motors (exept ø 630 mm) are equipped with bimetallic
thermal contacts in the windings, connected to separate
terminals in the box. Protection class IP54.
• Fan sizes Ø 450 & 500 available with four fan speed
alternatives (700/900/1150/1400 rpm), fans Ø 630 with
two fan speeds (900/1400 rpm).
• Casing material is polyesther coated hot dip galvanised
steel, colour white NCS 1002-4.
• Enclosed end covers.
• Double drip trays, easy to open and remove.
• Refrigerant distribution optimised to refrigerant applied.
• Sufficient room for fitting the expansion valve inside.
• Suitable for direct expansion or pumped system.
- DX standard for CA models
• Stickers indicate refrigerant in/out.
• A manual including installation and service instructions is
shipped with each unit
Design pressure
Design pressure 26 barg, higher design pressures on request.
Each heat exchanger is leak tested with dry air. Design
pressure for brine coolers is 6 barg.
FMP(G)
Dual discharge industrial air coolers
FMPG
