RETRACTABLE LOCATING PIN UNITS0 pages
UMiiiwm
nnnnPneumatic retractable locating pin units
nnnnHeadquarter
nnnn20128 Milano
nnnnVia Eraclito, 31
nnnnTel.+39 02 25298.1
nnnnFax+39 02 2575254
nnnninfo@univer-group.com
nnnnwww.univer-group.com
nnnnThe handling, positioning as well as the maintenance operations have to be carried out by observing all conditions which guarantee the
nnnnsecurity of the staff and only by authorized personnel.The residual risks regarding the sole maintenance phase consist in the squashing
nnnnof the upper parts of the operator's body. As a preventive measure an appropriate signalling or an adequate security system placed near
nnnnthe dangerous areas and which have to be installed by the user will alert the operator.
nnnn> Fixing instructions
nnnnThe fixing of the unit to the equipment can be carried out by using the front, or side part of the housing of the clamp. Before installing the
nnnnretractable locating pin unit, make sure that it hasn't been damaged during transport or handling operations.
nnnn■ Fixing
nnnn- Insert two hardened and grinded 08H7 pins into the special seats such as to locate the clamp
nnnn- Fix it steadily by using the indicated M8 screws, and make sure that they are about 8 mm deep in the thread holes, limiting the tightening
nnnntorque by 15 Nm
nnnnScrews | Tightening torque |
M6 | 8 Nm |
M8 | 15 Nm |
> Instructions for the connection of the clamp to its energy source
nnnnConnect the sensor of the clamp to its electric supply unit.
nnnnThen connect the pneumatic tube by means of suitable pneumatic fittings according to the specification below:
nnnnSeries LCI40 G1/8"fittings
nnnnSeries LCM50, LCP50, LCA63 G1/4"fittings
nnnnOperating pressure from 4 to 8 bar
nnnn> Electrical sensor
nnnnELECTRIC FEATURES
nnnnSupply voltage
nnnnSupply current without load
nnnnRated operational current
nnnnOutput logic
nnnnLed- supply
nnnnLed- close position- pin 2
nnnnLed- open position- pin 4
nnnn10 + 30Vdc
nnnn< 20 mA
nnnnMax 30 mA
nnnnPNP N.O.
nnnngreen
nnnnred
nnnnyellow
nnnnMole contacts Micro C Ml 2
"