F207 Load Washer0 pages
F207
Load Washer
Standard Ranges 10, 20, 40, 80, 100, 120, 160 and 200kN (1 to 20tonnef)
♦ Low profile with centre hole
♦ Ranges to suit bolt sizes from M6 to
M36
♦ Stainless steel construction
♦ Tensile applications are ‘fail-safe’
♦ Traceable calibration with certificate
included in the standard price
♦ Standard 2 year warranty
Geometry: Axial strain cylinder in weather sealed case, with raised end load bearing faces
and hole right through. For use in compression or in fail-safe tensile applications on a wide
range of OEM or end-user applications.
The F207 is ideally suited to engineering force measurements where overall height is
restricted; if a slight increase in height is acceptable the F313 may be a better choice.
It is designed for easy installation, usually between two flat faces bearing on its loading
rings, either unattached or with retaining spigots positioned in the centre hole. Alternatively
tensile load transfer can be achieved via a tie rod assembly through the centre hole. In this
way the loadcell can indirectly measure tensile loads in a “fail-safe” mode.
We are happy to design variants of this loadcell to meet your specific requirements.
Versions can be manufactured for fully compensated operation up to +250°C. Please
consult our engineering department.
Details of our other loadcell families can be found in the Product List and the Loadcell
Specifier Guide. If you require copies please contact our sales department or look on our
web site at www.novatechloadcells.co.uk.
Ordering Codes: See the loadcell ordering code sheet for more details. Add range in the required units.
F207CFR0K0
Compression, IP65, unrationalised
Change the K to an H for the 1 tonne range.
F207CFR0KN
Compression, IP65, rationalised
"