AMiNi0 pages

Compact Control Systems
Revision: II/08
amini-es_d_en_100
AMiNi-ES
Compact Control System with Ethernet Interface
AI.0 AI.1 AI.2 AI.3 AGND
1 2 3 4 5
IGND DI.0 DI.1 DI.2 DI.3 DI.4 DI.5 DI.6 DI.7 IGND
AI CONFIGURATION
SW
1 2 3 4
1 2 3 4 5 6 7 8 9 10
Rx232
Tx232
Rx485
Tx485
LNK
ACT
0
A
B GND
+24V GND
3
4
5
6
7
6
7
DIGITAL OUTPUTS
0
ETHERNET
27 26
2
RUN
ERR
S0
S1
S2
AMiNi-ES
30 29 28
1
DIGITAL INPUTS
SYST
EM L
EDS
ON
ADR0
ADR1
ADR2
ADR3
ADR4
BAUD0
BAUD1
SCOM
APPLIC
USER
HW
ON
6 7 8 9 10 11 12 13 14 15
SYSTE
M LED
S
8 × digital output 24 V / 0.3 A DC
8 × digital input 24 V AC/DC
4 × analogue input U / I / Ni1000
RS232, RS485 and Ethernet interface
35 mm DIN rail mounting
CONFIG
FLSH WR
BOOTSTR
RTS RST
•
•
•
•
•
RS232
1
2
3
4
5
25 24 23 22 21 20 19 18 17 16
E+24V DO.0 DO.1 DO.2 DO.3 DO.4 DO.5 DO.6 DO.7 EGND
TECHNICAL DATA
CPU
FLASH memory
RAM memory (battery back-up)
RTC (battery back-up)
EEPROM memory
Digital inputs
Universal AC / DC
Galvanic separation
Digital outputs
Galvanic separation
Outputs protection
Analogue inputs
Analogue inputs protection
Serial communication interface
Ethernet interface
Cover protection rate
Signal connection
Power supply
Power consumption (without outputs)
Operating temperature
Max. ambient humidity
Weight
Dimensions (w × h × d)
Back-up battery lifetime
Programming
*)
ST10F269
256 + 512 KB
1024 KB
Yes
2 KB
8 × 24 V AC/DC
Logical 0 min. –30 V, max. 5 V
Logical 1 min. 16 V, max. 30 V
Yes *)
8 × 24 V / 0.3 A DC
Yes *)
Internal protection of BSP452 switch
4 × 0 to 10 V / 0 to 5 V / 0 to 20 mA / Ni1000
Diodes + 10 kOhm resistor
RS232 (RJ45), according to EIA-561
RS485 without galvanic separation (WAGO connectors)
10 Mbps, RJ45, according to IEEE802.3
IP20
WAGO 734 (3.81 mm) cage clamp connectors
24 V AC ±20 %
Max. 250 mA at 24 V DC
0 to 50 °C
< 95 % non-condensing
180 g
106 × 95 × 74 mm
5 years
DetStudio
Insulation strength 300 V AC / 1 minute, galvanic separation may not be used for safe and unsafe
parts separation.
ORDERING INFORMATION
AMiNi-ES
KABEL 232RP
Compact control system, full connector set, user’s manual, warranty card
RS232 to PC connecting cable
AMiT, spol. s r.o., Naskové 3/1100, 150 00 PRAGUE, Czech Republic
Tel.: +420 222 780 100, +420 222 781 516, Fax: +420 222 782 297
e-mail: amit@amit.cz
Technical support: support@amit.cz
Tel.: +420 549 210 276, +420 549 210 403
www.amit.cz/support