MicroVantage WGAS Series Water Grade0 pages

MicroVantage™ WGAS Series
Water Grade Polyethersulfone Membrane Filter Cartridges
•t Absolute retention ratings from 0.3 to 1.0 microns
•t 6.0 square feet (0.56 m2) of media surface area per ten inch
length for optimal performance
•t Cost effective absolute filtration for less critical applications not integrity tested
•t 100% polypropylene construction offers wide range of
chemical compatibility
•t Rigid, molded cage protects pleated media and strengthens
structural stability
•t Manufactured in state-of-the-art white room environment for
high purity
•t Complies with Food & Drug Administration’s CFR criteria for
food & beverage contact
•t Meets USP Class VI Biological Test for plastics.
•t Available in common end cap configurations to fit most filter
housings
•t Produced in standard lengths up to 40 inches
Applications
RO Pre/Post Filtrationtt
DI Watertttt
Plating Solutionsttt
Specialty Chemicalstt
Water & Wastewatertt
Food & Beverage
Bottled Water
Microelectronics
Process Water
Cosmeticst
Specifications & Operating Parameters
Pore Sizes 0.03, 0.1, 0.2, 0.45, 0.65, 1.0 microns absolute retention
Nominal Lengths 9.75" (24.7 cm), 10" (25.4 cm), 20" (50.8 cm),
Maximum Operating Temperature 176˚F ( 80˚C)
Recommended Change-out Differential Pressure
30" (76.2 cm), 40" (101.6 cm)
35 psid (2.4 bar)
Outside Diameter 2.67" (6.78 cm)
Maximum Differential (Collapse) Pressure
Inside Diameter 1.0" (2.54 cm)
75 psid @ 70˚F (5.2 bar @ 21˚C), 40 psid @176˚F (2.8 bar @ 80˚C)
Media Surface Area 6.0 sq.ft. (0.56 m2)
Sanitization and Sterilization
per 10 inches filter length
Gaskets/O-rings
Silicone, Buna N, EPR, Viton, Teflon Encapsulated Viton
(O-rings only)
Materials of Construction
Filter Media: tt
Outer Cage tt
Inner Core: tt
End caps: tt
Asymmetric Polyethersulfone
Polypropylene
Polypropylene
Polypropylene
Hot water at 175˚F (80˚C) at 5 psid for 30 minutes
In-line steam at 257˚F (125˚C) @ 1 psid (0.7 bar) for 30 minutes
Autoclavable at 257˚F (125˚C) for 30 minutes
FDA and USP Compliance
All materials comply with the requirements of Food and Drug
Administration Title 21 of The Code of Federal Regulations 174.5,
177.1520 and 177.1630. All components meet current USP Class
VI biological tests for plastics
www.shelco.com