Display indicators SX6500 series0 pages
Inertial sensors and systems
Display indicators for inclinometers
Description
General specification at +25°C
SX6502 & SX6503 display indicators have common functions:
Maximum errort
t
±0.1% of the reading
+ 2 digits
Temperature coefficientt
Displacement sensors
SX6502 & SX6503 series
100ppm/°C
-t Plug/ unplug terminals
-t Programming lock out to prevent unauthorized or accidental modifications of set-up parameters
Characteristics:
-t Programmable display between -32000 and +32000
-t 30 points (maximum) linearization
-t Several level filters: balance, damping and round filter
-t Sensor built-in power supply
-t Optional control cards:
t -t Analog (4-20mA or 0/10 VDC)
t -t 2 thresholds by 2 relays
t -t 4 thresholds by 4 relays
-t Optional communication cards:
t -t Serial RS 232
t -t Serial RS 485
-t Control of TARE, RESET, LIMIT, MAX/MIN functions
on the front panel. Other functions may be validated
through logical inputs.
-t ARC sinus function: this function is used with inclinometers which output is proportional to the sine of the inclination angle. This enables to convert the acceleration
measurement (g) to degree of inclination (°).
Warm-up timet
10 minutes
Resolutiont
±16bits
Ratet
16/s
Linearizationt
30 points
Main displayt
t
5 red digits 14mm,
-32000/+32000
Decimal pointt
Programmable
LEDst
t
14 (programming
and control)
Display update timet
62ms
Filter P/ cut-off frequency (3dB)t
from 4Hz to 0.05Hz
Slopet
t
from 14 to 37 dB
by decade
Filter E (programmable)t
10 levels
Protectiont
IP65
Operating temperaturet
-10°C to +60°C
Storage temperaturet
-20°C to +85°C
Relative humidityt
< 95% ±40°C
Selection guide
Power supply typet
Product reference
Power supply 230 Vac 50/60Hzt
690 241 200
Power supply 24Vdct
690 241 210
01/13 | SX6502 & SX6503
Meggitt (Sensorex) | Archamps Technopôle | 196, rue Louis-Rustin | 74166 ARCHAMPS - France
Tel. (+33) 450 95 43 70 | Fax : (+33) 450 95 43 75 | Internet : www.sensorex.fr & www.meggittsensingsystems.com
- 31 -
Electronics and microelectronics
-t « ready to install » format
Intrinsically Safe (IS) products
-t Input selection in voltage or current
"