Special displacement system for holding and transporting sheet metal0 pages
www.thyssenkrupp-magnettechnik.com
ThyssenKrupp Magnettechnik
Displacement system
for holding and transporting sheet metal
When handling equipment for sheet bars or thin sheet metal was designed in the past, grapplers or
pneumatic vacuum devices were used for preference to date. An electrically switchable magnet system
now makes it possible to design smaller units which also have a high adhesive power. This avoids also
the considerable disadvantages of these grapplers and suction cups, the mechanical wear and tear, the
cost-intensive conditioning of air and the restricted possibilities of use.
The small dimensions at the same time as a high adhesive power mean that this system can be
deployed universally, e.g. in the case of very short or heavily moulded sheet bars as well as in the case
of those which have many punchouts or holes. The small dimensions are possible thanks to the use of
modern magnetic materials such as samarium cobalt. This increases the specific adhesive power and
thus also the safe transportation of heavy and thick iron items.
The chosen geometry makes the removal of the sheet bar possible in two different ways, either
longitudinally or transversely. In addition, this system can be used for lifting or pushing. The magnet
system has its full adhesive power when it is not supplied with electricity, and only when there is a
defined flow of electricity through the integrated coil the system becomes non-magnetic. In accordance
with VDE 0580 (Association of German Electrical Engineers) (air gap = 0.1 mm), the minimum adhesive
power - without electricity - is 30 to 40 kp, depending on the type. On the other hand, it is possible to
increase further the adhesive power of the magnet system by reversing the direction of current.
We supply three different types of the above-mentioned systems: they are different both in their
adhesive power as well as in their duty cycle. Depending on type, the duty cycle is approx. 75%, 40% or
20%. These types are specially suitable for the following applications:
lifting applications for transporting heavy and thick iron items,
such as rails, pallets, gas cylinders, etc.
removal and transportation applications of sheet metal blanks, shaped items and sheet
bars from pressing, punching, sheet bar loaders and feeding these parts to robots.
Johanniskirchstraße 71
45329 Essen, Germany
Tel. +49 (0)201 946161-0
Fax +49 (0)201 946161-555
The high specific adhesive power of this generation of systems means that there are also further
applications in other branches of industry.
1