Permanent magnetic spreading magnets0 pages
www.thyssenkrupp-magnettechnik.com
ThyssenKrupp Magnettechnik
Permanent magnetic spreading magnets
As the name already
indicates, this kind of
spreaders only consists of
permanent magnets.
The front view can be seen below and has the following arrangement:
Iron plate
Magnet
Sheet
Typical arrangement of a permanent magnetic spreading magnet
The arrangement of the spreading magnet can be seen. It represents an iron plate with permanent
magnets sticking to them with the polarity specified; ‘north’ designates the north pole of the magnet
which should be homogeneous on the complete area; ‘south’ designates the south pole of the other
magnet. The sheet should stand perpendicularly on this area. The area of the magnets is covering
about 90% of the working area.
Johanniskirchstraße 71
45329 Essen, Germany
Tel. +49 (0)201 946161-0
Fax +49 (0)201 946161-555
The dimensions of permanent magnetic spreaders are normally smaller, because of the tremendous
attractive force, which can not be switched off. Due to this the max. system width will not exceed
250mm by a system height of 400mm. When the dimensions are getting smaller, there is no real
choice than to take permanent magnetic spreaders. As a smallest dimension you can take a width of
70mm with a height of also 70mm. In this case you can even fan round shaped sheets like the lits of
cans. An increasing spreading power can be achieved by using better magnet material. For such a
case the typical ferrite magnet is replaced by NdFeB magnets.
1