LOADING
Hydraulic punching from coil for staircase steps0 pages
نسخه متنی
"This cost effective line has made the O.E.M.able to produce in-house the whole family ofstaircase steps previously subcontracted. Line performances : From 3 ton coils, manufacturingof thick gauge parts (up to 4 mm).Part size range :
Hydraulic punching from coil
nnwww.dimeco.com
nnMetal staircase steps nnThis cost effective line has made the O.E.M.able to produce in-house the whole family ofstaircase steps previously subcontracted. Line performances : From 3 ton coils, manufacturingof thick gauge parts (up to 4 mm).Part size range :
- length from 800 to 2000 mm,
- width from 40 to 500 mm.
Average output : 2 m/min. Avantages of the solution : Depending on the shape to punch and its
location, the system selects either, one of the
two symmetrically adjustable C framed 10 ton
hydraulic punching stations, or, one of the
two 80 ton punching or embossing column
guided hydraulic tools.
The MultistepӔ DIMECO patented technology
allows the system to produce parts of different
lengths and patterns one after each other withno scraps nor stop.The punched strip is then cut with a hydraulic
shear and the cut to length parts are stacked
on a 3 ton lifting table equipped with automa-
tic stack levelling.
The parts are then bended on a separate cell.
Tl. +33 3 81 48 38 00 - contact@dimeco-alipresse.com Tl. +33 1 60 38 12 80 - contact@dimeco-profical.com T驩l. +34 943 639 004 - dimeco@dimeco.es >
"