FlowHUB Series Flow, Temperature,Measure, display, switch, transmit0 pages

FlowHUB Series
Flow, Temperature,Measure,
display, switch, transmit
Up to
l 360 lpm, 100 US gpm
l 420 bar, 6,000 psi
The FlowHUB is ideal for condition monitoring, test stands and closed
loop control applications both for fluid power and lubrication systems.
The FlowHUB can measure and display flow and temperature readings
as well as switch and transmit flow values. This enables a system designer
to trigger alarms, shutoffs and transmit real-time values to a PLC using
just one component, instead of up to six which might have been required
conventionally. This represents a significant cost saving in terms of reduced
complexity of wiring and far fewer components.
It is available in five flow ranges from 1 to 360 lpm (0.25 to 100 US gpm) and
in two pressure ranges 210 and 420 bar (3,000 and 6,000 psi). The FlowHUB
is available in three versions - ‘Switch’, ‘Transmitter’ and ‘Ultimate’, all three
versions have built in temperature measurement and a large bright digital
display.
The ‘Switch’ version provides two configurable switched outputs; the trigger
flow rate, time delay, sense (above/below) and normal mode (normally closed
/ normally open) can all be freely configured. Each switch is independent and
can switch up to 500 mA. The ‘Transmitter’ version provides a conditioned
output either 0 to 5 Volts or 4 to 20 mA - full scale is configurable to any
maximum flow. The ‘Ultimate’ version
has both the switches and transmitter
and the highest pressure rating of 420
bar (6,000 psi) as well as an enhanced
response time of 50 ms.
Other configurations are available on
request.

Milwaukee, WI 53235, USA
Tel: +1 (414) 769-6400
sales-us@webtec.com
St. Ives, Cambs. PE27 3LZ, UK
Tel: +44 (0) 1480 397 400
sales-uk@webtec.com

www.webtec.com

Features
ltFLOW: 1 - 360 lpm,
t 0.25 - 100 US gpm
ltPRESSURE: Up to
t 420 bar, 6,000 psi
ltDESIGNED for permanent
installation (few wearing
parts)
ltEASY to operate
tt
4 digit LED display
tt
3 large keys
ltACCURACY better than
t 3% FSD
ltREPEATABILITY better
t than 1%
ltTEMPERATURE
measurement built-in
ltWIDE RANGE OF
OPTIONS: Choice of
outputs V or mA. Two
programmable switches.
Complete with adaptors
fitted (BSP or JIC Male).
Engineering units lpm or
US gpm (°C or °F)
ltEASY INSTALLATION
t Mount in any orientation
t Install straight after a
bend. Allows reverse flow
ltTRACEABLE calibration
on request
ltPATENT Pending Design

Certificate No.8242

Hydraulic measurement and control

FLOWHUB-BU-ENG-2284.pdf 11/13
(Issue 3)