Cross Platform Starter Kit 2.00 pages

Development Kit

Qseven

Cross Platform
Starter Kit 2.0
Qseven® Rev. 2.0 Carrier Board on 3.5” Form factor
The Cross Platform Starter kit is a complete package that contains
the basic components necessary to start developing with Qseven®
Rev. 2.0 compliant CPU modules, both on x86 and on ARM
architectures.

•t
•t
•t
•t
•t
•t
•t

Carrier board for Qseven® Rev. 2.0 compliant modules SECOCQ7-3.5 (DP or
HDMI version)
7” LVDS optional Display (800x480) UMSH-8596MD-20T
LVDS display adapter + connection cable to SECOCQ7-3.5 carrier board
HD Audio module
I2S Audio module
One 12VDC Notebook Power Adapter
Cable kit

FEATURES OF SECOCQ7-3.5
Video Interfaces

Mass Storage

LVDS Dual Channel 24-bit + backlight connectors or 2 x
eDP connectors
DP++ or HDMI Connector
1 x S-ATA with HDD Power connector
1 x mSATA Slot
microSD Slot on combo microSD + SIM connector
Up to 2 x Gigabit Ethernet connections

USB

1 x USB 3.0 port Type-A socket
2 x USB 2.0 ports on double Type-A socket
2 x USB 2.0 ports on internal pin header
1 x USB 2.0 OTG ports on micro-AB socket (USB Port
shared with miniPCI-e slot)
Optional Debug USB port on mini-B Socket

PCI-e

miniPCI-e slot Full/Half size, combined with SIM card slot

Audio

Audio interface on internal pin header

Serial Ports

Other Interfaces

Power Supply

•t Schematics
•t Design Review

050.15

Networking

Information subject to change. Please visit www.seco.com to find the latest version of this datasheet

The Carrier board contained in the Kit can be used with any SECO Qseven® Rev. 2.0
compliant CPU Module. The Kit itself DOES NOT CONTAIN any Qseven® module,
which has to be purchased separately.

4-wires RS-232/RS-422/RS-485 configurable serial port
on DB9 male connector
Optional 2 x RS-232 Full-modem serial ports on internal
header (needs LPC interface on Qseven module)
CAN interface on PCB terminal block
SPI internal pin header
LPC Bus internal pin header
SM Bus / I2C GPIO expander, makes available 16 x
GPIOs on internal pin header
Front Panel Header
1 x 28 pin connector for additional features (I2C, ACPI
signals, SM Bus, Watch Dog, Thermal Management)
3 pin header, with fan speed control, +12VDC
+12V Mini-fit Standard ATX power connector
Coin cell battery Holder for CMOS and RTC

Operating
Temperature*

-40°C ÷ +85 °C (industrial range)

Dimensions

146 x 102 mm (5,75” x 4,02”)

*All carrier board components must remain within the operating temperature at any and all times,
including start-up; carrier operating temperature is independent of the module installed. Please refer to
the specific module for more details. Actual temperature will widely depend on application, enclosure
and/or environment. Upon customer to consider specific cooling solutions for the final system.

www.seco.com