ABR-300 / ABR-7500 pages

ABRASIVE VESSEL ABR-300 / ABR-750
RPN 1048945 / 1048946

The abrasive vessels are used to store
and supply abrasive for the waterjet cutting machines. They consist of
a pressurized vessel with internal
charging valve. This valve, also called
‘pop-up valve’, closes when the pressure builds up and opens when the
vessel is depressurized.
To prevent blockage of the abrasive supply by large objects and pieces of paper
or plastic bags, a screen has been placed
over the filling port on top of the vessel.
This screen is provided with a cover to
prevent water and moist entering.
Air supply and control valves are mounted on the outside of the vessel. Operating pressure can be adjusted by a pressure regulator to match machine setup
and hose length.
An internal capacitive proximity sensor,
located near the bottom of the vessel,
senses if the abrasive level is low.

OPERATION
A low abrasive level in the storage vessel will trigger a low level signal on the
operator console. If this is not acted
upon, the abrasive will drop below the
minimum level, automatically stopping
the cutting process. It is essential to
keep the abrasive dry. Wet abrasive will
stick inside the vessel and may cause
blockage of the abrasive supply.

ORDERING CODE

RPN 1048945 / 1048946
+31 (0) 50 501 6877
wjsales@resato.com
www.resato.com

KEY FEATURES
1 Supplying abrasive for the waterjet machine
2 Prevents contact between abrasive and water
and moist
3 Can be place underneath an abrasive storage
silo