Isotop® FK0 pages
Isotop FK
®
Spring caps
Design
Isotop® spring caps are used for fitting onto Reinicke
steel spring isolators of the series SD. They consist of
high-performance natural rubber. The thickness of
the top bearing is 10 mm.
Field of application
Isotop® spring caps are used where a non-slip fitting is
required without direct screwing onto the spring.
Advantages
— onstruction height and diameter are identical for all
C
types, which guarantees exchangeability.
— n conjunction with Isotop®-steel spring isolators of
I
the series SD the separation of structure-borne noise
is significantly reduced.
— Due to the high friction factor of the material screw
less mounting of the device directly on top of the steel
spring and caps will be possible, unless it is mandatory
or has been planned by the structural engineer.
— Centre of gravity, wind load and other forces have to
be considered.
Isotop® FK
Selection table
Isotop® FK combined with Isotop® SD
Description
Ref. no.
Isotop® FK
45000503
All data indicated are based upon our current knowledge.
They may be used as calculation and standard values and are subject
to the usual machining tolerances. Subject to change and correction.
www.reinicke-gmbh.de
Voithstraße 26 71640 Ludwigsburg Deutschland T +49-7141-79179-0 F +49-7141-79179-11 info@reinicke-gmbh.de
DB Isotop® FK en © Copyright by Reinicke GmbH l 06-2013
We reserve the right to amend the data.
Our service
Make use of our know-how on questions about vibration
technology. We will gladly consult you and will calculate
customized solutions for vibration isolation.