Series 12 (J /JC)0 pages

SPECIFICATIONS

OPTIONS AVAILABLE

Angleof throws : 30°, 45°, 60°, & 90°

available

Contact rating Silver plated brass con-

tacts can switch 1 Amp

(resistive load at 28 VDC

and 0.5 Amp (resistive) at

110 VAC

Silver alloy contacts can

switch 2 Amps (resistive) al

28 VDC and 1 Amp

(resistive) at 110 VAC.

Contact rating requirement

on resistive loads as per

SRW06of JSS 51207

500 mA at 28 VDC

125mA at 230 VAC

Contact resistance 3 to 15 milliohms between

adjacent contacts.

Inulation resistance 1000 megohms min. for

J switch 10,000 megohms

Min. for JC switch

Dielectric strength 1000 VAC at sea level

Temperature Range Standard commercial

-25°Cto+85°C

Military (Phenolic)

-65°Cto+125°C

Finishes All component parts

requiring plating are

cadmium, nickel or zinc

plated and passivated as

per our standards.

Sections

Sections of phenolic and ceramic can be combined in a

switch to keep cost down, when insulation is critica for

only certain circuits.

Stops

Fixed stops at total number of positions specified are

standard. If OFF position is required please indicate

whether it is to be at the first or last switch position.

Water Seal

'O' ring sealing is available for both shaft and index

housing. Water sealing meets JSS requirements.

Clip Terminals

Standard terminals have 75 bend. Clips with flat or

reverse terminals are also available on request.

Printed Circuit Terminals

Silver plated Brass PC. terminals are available

assembled with the switch clips (See figure for terminal

details and drilling pattern).

Electrostatic shields, Moulding brackets, etc. are

available as standard, and can be supplied when

specified.

Gold Flashing/Plating

Gold flashing or gold plating can be provided over silver

alloy when specified to improve storage characteristics,

dry circuit switching, increase reliability when used

infrequently or in corrosive atmospheres limit contact

resistance variation: (See under Military specifications