e.bloxx A4TC Multi channel module for thermocouples and voltages up to 80 mV0 pages
Multi-Channel Thermocouple and mV Module
The e.bloxx series is designed for industrial and experimental test systems requiring precise high speed measurement of electrical, thermal, and mechanical quantities in engine and component test beds. All units are based on a clean modular design, and easily connect to the wide variety of field devices used in todays test beds. Sample rates up to 5000 Hz and resolutions up to 19 bit are possible depending on the module and signal type used. Standardized communication protocols (Profibus-DP and Modbus-RTU) allow the e.bloxx family to work with a wide variety of application hardware and software. Adding an e.series Test Controller dramatically increases the systemҒs throughput and connectivity options. An e.series Test Controller is a data concentrator, communication gateway, and optionally a Programmable Automation Controller (PAC) with 100Mbps Ethernet, Profibus-DP, EtherCAT, or USB ports. EthernetTCP/IP >
nn4 or 16 analog, high speed, galvanic isolated channels
Thermocouple and 80 mV (100 samples/sec with 4 active channels) >
nnU
nnCold junction compensation
CJC per terminal strip (special terminal block required) >
nnDynamic linearization
Optimised linearization for the types B, E, J, K, L N, R, S, T, U >
nnSignal conditioning
Linearization, digital filter, averaging, scaling, minimum/maximum, arithmetic, alarm >
e.bloxx A4-1TC e.bloxx A4-4 TC
RS 485 fieldbus interface
Profibus-DP, Modbus-RTU, ASCII >
nnOrder Information Additional Features
Product Article No. Accuracy 0.01 % e.bloxx A4-1TC 245074 e.bloxx A4-4TC 245175 AccessoriesConfiguration Software ICP 100 633214 Cold Junction Compensation e.bloxx Terminal CJC 111874 Interface Converter RS232 / RS485 ISK 200 236314 ISK 101 689326 ADC resolution and internal calculation accuracy of 19 bits Measuring rate 100 samples/sec per channel (4 active channels) Linearization, scaling, and data formatting Data transmission up to 1.5 Mbps Up to 32 modules on a single two wire RS-485 interface PC-Software (ICP 100) for easy configuration of the modules Galvanic isolation of I/O-signals, power supply, and communication interface Power supply 10 to 30 VDC DIN rail mounting (EN 50022 rail) Pluggable screw terminals for field, power, and communication connections Electromagnetic Compatibility according to EN 61000-4 and EN 55011 >
Gantner Instruments Test & Measurement GmbH www.gantner-instruments.com office@gantner-instruments.com Montafonerstraџe 8 A-6780 Schruns / Austria T +43 (0) 5556 73784-410 F +43 (0) 5556 73784-419Industriestrae 12 D-64297 Darmstadt / Germany T +49 (0) 6151 95136-0 F +49 (0) 6151 95136-26 size="-1">