V-2500 pages

V-250
Fiber Optic
Video Link
Features
• Easy to Install and Use • Eliminates Ground Loops
• Low Cost
• 5 Km Transmission Range
• AGC is Standard

Call, Fax or Email
your application requirements

The V-250 is designed for transmitting high quality video in any standard format
over much longer distances than are possible with coaxial cable. Simple to
install and use, the built-in automatic gain control eliminates the need for
adjustments. This rugged, low-cost system is immune to the effects of radiated
interference, high voltage differentials, water, ground loops, and the effects of
hazardous environments.

Specifications
The V-250 video transmission system consists of the
VXM-250 Fiber Optic Transmitter, the VR-250 Fiber Optic Receiver and two 115/240 VAC power adapters. The
system is fully compatible with NTSC, SECAM, PAL and
D2MAC video standards. Small in size, the VXM-250
mounts directly on the output BNC connector of the camera or video source. The VR-250 is equipped with an automatic gain control that automatically compensates for varying cable lengths, degradation of splices and variations in
video signal strength. The unit comes equipped with a bicolor LED that indicates the presence of video signals and
proper operation of the units. Versions are available with
either ST* or SMA fiber optic connectors. The ST connector is compatible with 50/125 or 62.5/125 µm fibers, while
the SMA will also accomodate 100/140 µm fibers. The VX250 operates at an optical wavelength of 850 nm. With its
16 dB link budget it can support transmission distances in
excess of 5 km. If greater distances are required, the VX250 - 1300 is available. This unit operates at a wavelength
of 1300 nm. At this wavelength fiber losses are much lower
and thus a concomitantly greater range is possible.

*Registered Trademark of AT&T

System Bandwidth ... 10 Hz-10 MHz (-3dB)
Input/Output Impedance ............ 75 Ohms
Nominal Input/Output Voltage ....... 1 V p-p
Operating Wavelength .......... 850/1300 nm
Optical Connectors .................. ST or SMA
Signal Connectors ............................. BNC
Link Budget (850/1300)** ............ 16/14 dB
Differential Gain ...................... 2 % Typical
Differential Phase ........ 2 Degrees Typical
Signal to Noise Ratio ....... 65 dB Minimum
Operating Temperature ................ 0 - 50 C
Dimensions..1.5” dia., 1.5” L, 4.5”x2.5”x1”
Power Req.............. 120/240 VAC 50-60 Hz
**62.5/125 µm fiber

169 Clear Road
Oriskany, New York 13424
Tel: (315) 736-3642
Fax: (315) 736-4078
Web Site: www.borg.com/~tti/
E-mail: tti@borg.com