NSC-M Series Controller0 pages

NSC-M Series

The NSC-M Series motion controllers are designed

for use with all Newmark stepper motor systems. The

controller can communicate with the host computer

through an RS-232 interface. It can manage up to four

axes and perform coordinated or independent motion

of each or all the axes simultaneously. With built-in

high level functionality, such as circular and linear

interpolation, multi-tasking and custom profiling,

programming the controller is greatly simplified.

" OM5-EZ(tm) Win32 Terminal

File Terminal Help

Terminal | Cmd Script |

{Attempting to contact OMS device___}

(Connecting to PCS3 (RS-232) on C0H1)

(Handle acquired for 'PC68 (RS-232)'}

The motion controller can operate

as a stand-alone system through

the RS-232 port. It utilizes a 32-

bit microprocessor to control the

trajectory profile, acceleration,

velocity, deceleration and direction

of selected axes.

Our multi-axes controller is

commanded using virtually any

programming language to pass

simple ASCII command strings to

the controller through the RS-232

port.

Program Sample

This program will move the motor 34,000 steps back and forth until

the stop(ST) command is executed.

AX

AC100000

VL25000

WH

MR34000 GO

MR-34000 GO

WG

* address the X axis

* set acceleration to 100,000 steps/sec2

* set velocity to 25,000 steps/sec

* start of loop for repetitive motion

* move relative +34,000 steps

* move relative -34,000 steps

* loop back to starting WH command

The terminal software is an easy to setup and use

interface for NSC-M programming.

Model Description

NSC-M2 Two Axes Stepper Motor Controller

NSC-M2-E Two Axes Stepper Motor Controller with Encoder Feedback

NSC-M3 Three Axes Stepper Motor Controller

NSC-M4 Four Axes Stepper Motor Controller

Ordering Information