Accessories for Penetrant Testing0 pages

Accessories for Penetrant Testing

Ni-Cr Test Panels – a range of process control panels having finely controlled crack depths to
offer greater discrimination when comparing penetrant sensitivity. Matched pairs of panels are used
to study the effects of process change.
Available in pairs, in the following crack sizes:
s,
Part number 506251
Part number 506252
Part number 184400

10 microns
20 microns
Panel set – 10, 20, 30, 50 micron

Aluminium Test Block
Part number 070C001
Cracked aluminium block compares SENSITIVITY of different penetrants or SENSITIVITY of new against
old (working) penetrants. Complies with MIL
MIL-1-25135.

Stainless Steel Test Block
Part number 154400
Monitors WASHABILITY of water washable or post emulsifiable penetrants. May be used repeatedly if
emulsifiable
thoroughly cleaned after each use.

TAM Crack Comparators
Part number 514048
General purpose crack comparator (in increments from 0.005 – 0.125”)
Part number 514049
General purpose crack comparator (in increments from 0.2 – 3.0 mm)
Part number 514050
TAM crack comparator (Pratt & Whitney reference TAM 135273), (in increments from 0.10 – 0.180”, 0.2 –
4.6 mm)

Refractometer
Part number 008M009
A hand-held optical instrument used for measuring the concentration of hydrophilic removers in water.
held
In operation, a small sample of the solution is applied to the prism face. Readings are then taken by looking
into the instrument at the built-in scale.

UV Absorbing Spectacles
Part number 017G001
Specifically designed to eliminate long wave UV(A) and protect the eyes during excessive periods under
ultraviolet lighting, these spectacles also reduce fatigue and provide an optimum contrast in viewing.