Europe Pneumatic Air Trip Assembly0 pages
Mactech Europe LTD
Mactech Pneumatic Air
Trip Assembly
Built for Safety
The Mactech Europe Air Operated Trip assembly has been introduced
to offer safe remote operation of the feed trip pin combined with a two
handed start control.
This ensures the operator has full control of the operation of the
clamshell lathe while remaining outside the potentially hazardous
zone.
The start handle and the trip assembly use air taken from the main air
supply to the clamshells pneumatic drive motor and no other power
source is required.
If the operator releases the run control the machine will come to a stop
and the feed pin retracts automatically.
ID Clamping End Prep Tool (model C-314)
3.75” (88. 9mm).ID to 14” (355.6mm) OD
Mactech Commander EPL
To start the machine the operator must use both hands, after start up
only one hand is needed to keep the machine running, leaving the
other hand free to operate the control of the feed pin.
The air operated trip assembly is a direct replacement for the manual
version with no other modifications necessary.
Mactech Europe Limited
Unit 7, Scragg House, Langley Business Park, Langley Rd,
Langley, Macclesfield, Cheshire, SK11 0DG
Tel: 01625 503 306 Fax: 01625 618 147
Email: info@mactecheurope.co.uk www.on-site-machining.co.uk
Email: info@mactecheurope.co.uk www.on-site-machining.co.uk