AC Servo Controllers AMC10, AMC11 and AMC120 pages

LD0016-03GB Date: 5-1-05
AC Servo Controllers
AMC10, AMC11
and AMC12
AMC10, 11 and 12 are a series
of AC Servo Controllers which
can be used to control both AC
and step motors rated up to
1kW.
The Controllers are based on a
16-bit microprocessor and 32-
bit signal processor, and are
characterised by great flexibility
for a wide range of control
applications.
The Controllers can be controlled
directly via the built-in
RS232/RS485 interface, or
indirectly via 6 digital inputs. In
addition, models can be supplied
with a built-in Fieldbus
interface. The Controllers can be
directly connected to PLCs
equipped with controller modules.
Up to 255 units can be connected
to the same RS232 bus,
and thus a PC or PLC can
function as controller for a
multi-axis system.
Using JVL´s programming
software, MotoWare, motorpower,
velocity, torque etc., can
be monitored graphically and
comparisons made with previously
recorded curves. This
facility greatly assists control
and troubleshooting.
• Compact and programmable
• EMC tested. CE-marked
• Built-in RS232/RS485 Interface
• Fieldbus models available
• Simple programming using
MotoWare
• Facility for graphic monitoring
• Electronic gearing with high
resolution
• Can be used for both ACServo
and Step motors up to
1kW
• Use FLASH-PROM, can be
reprogrammed
• Absolute or relative positioning
• Programmable velocity profiles
• Driver stage 6 and 12A
• Digital control loop
• Automatic zero-point seek
• 11 inputs, 8 outputs
• Current and voltage overload
protected
• Short-circuit and thermal
protection
• End-of-travel limit inputs