TXK | mechanical steel jack | HVP | industry0 pages
TXK
HOISTS-CRANES-COMPONENTS
MECHANICAL STEEL JACK
ModehHVP
Technical specialities
Double pawl brake system - quick braking, safe and reliable.
Low gearing tolerance - smooth transmissions, free of jerks.
High efficiency and minimum turning force less than 25 kgs is requried to lift full load of all rated capacity
Sturdy structure, light weight and quick lift performance.high quality material CRS plate, carburized alloy
steel gears.
HVP-1.5
HVP-3
HVP-5
HVP-10
HVP-16
HVP-20
Safe Working
Load
(Ton)
1.5
3.0
5.0
10
16
20
Height of
Load
(mm)
725
725
725
800
950
950
Lifting
Height
(mm)
350
350
300
300
400
400
Height of Claw in Net Weight
Lowest Position (k .
(mm) 1 a'
70
75
70
90
95
95
13
20
27
47
64
73
WARNING
Inspection prior to
use as per operating
manual
The steel Jack HVP is
designed and developed for
heavy industrial lifting
applications, strictly in
accordance with the lastest
safety standard DIN 7355.
Operation Guide
Put the steel jack on even places. Then place the goods on the Lower Support Stand(4) or the Upper Support Stand(3).Shake
the Level(2) clockwise to lift the goods.vice verse.the goods are lowered down.
(1)Base
(2)Level
(3)Upper Support Stand
(4)Lower Support Stand
(5)Upper Ratchet Pawl
(6)Lower Ratchet Pawl
(7)Axle Ring
Attention
Do not exceed the rated capacity. Overload is forbidden.
Before operation, please check the flexibility of the Ratchet Pawls (5),(6)
Please be sure the jack is on complete balance when operating. Do not put it on beveled, arc or uneven surfaces. The jack must
be placed on hard plain grounds.
Before lifting, please be sure the Support Stand(4)(3)supports the goods completely.
When several jacks are used at the same time, please be sure of the same lift or down. The whole operation course should be
directed.
If s forbidden putting any parts of the body under the lifted goods.
If working force is abnormal in operation, please stop working immediately to inspect all related transmit components.
Lubricate parts applied regularly.
The Upper Support Stand(3) should be on bottom position when the jack is not used.
Hoists Cranes Components
"