Cleaner Blend 3000 pages

Technical Data Sheet
1/26/2012

Cleaner Blend 300
Description:

Cleaner degreaser agent used to remove oils, grease, dirt and dust from metal surfaces before using any Devcon
products.

Intended Use:

- Any metal surfaces, alloys and porous castings
- Used on rubber surfaces, plastics, wood and concrete surfaces
- Removes dirt, oil, tar, and grease

Product
features:

Leaves no residue
Fast evaporating

Limitations:
Typical
Physical
Properties:

Technical data should be considered representative or typical only and should not be used for specification purposes.
Cured 7 days @ 75° F
Flashpoint

Surface
Preparation:

105°
F

1. Thoroughly clean the surface with Devcon® Cleaner Blend 300 to remove all oil, grease and dirt.
2. Grit blast surface area with 8-40 mesh grit, or grind with a coarse wheel or abrasive disc pad, to create increased
surface area for better adhesion (Caution: An abrasive disc pad can only be used provided white metal is revealed).
Desired profile is 3-5mil, including defined edges (do not "feather-edge” epoxy).
Note: For metals exposed to sea water or other salt solution, grit-blast and high-pressure-water-blast the area, then leave
overnight to allow any salts in the metal to “sweat” to the surface. Repeat blasting to “sweat out” all soluble salts. Perform
chloride contamination test to determine soluble salt content (should be no more than 40ppm).
3. Clean surface again with Devcon® Cleaner Blend 300 to remove all traces of oil, grease, dust or other foreign
substances from the grit blasting.
4. Repair surface as soon as possible to eliminate any changes or surface contaminants.
WORKING CONDITIONS: Ideal application temperature is 55° to 90° In cold working conditions, directly heat repair
F
F.
area to100-110° prior to applying epoxy and maintain at this temperature during product cure to dry off any moisture,
F
contamination or solvents, as well as to achieve maximum performance properties.

Mixing
Instructions:
Application
Instructions:

Severe surface contamination may require mechanical preparation prior to the application of Devcon Cleaner Blend 300.
This may be accomplished through abrading, grinding, or shot blasting. Following this procedure, Cleaner Blend 300
should be applied generously and completely over the desired surface. The area should then be thoroughly wiped with a
clean cloth and allowed to dry prior to application of epoxy or urethane products.

Storage:

Store at room temperature, 70 °
F.

Compliances:

None

Chemical
Resistance:

Rating chemical resistance is not necessary for this product.

Precautions:

Please refer to the appropriate material safety data sheet (MSDS) prior to using this product.
For technical assistance, please call 1-800-933-8266

FOR INDUSTRIAL USE ONLY
Warranty:

ITW Polymers Adhesives North America , 30 Endicott Street, Danvers, MA 01923

Tel:(978) 777-1100 www.itwadhesives.com