STATIPOWER®SP180 pages
SP18 Rev2
1/4/07
11:29 AM
Page 1
®
STATIPOWER SP18
Transistorized Induction
Heating Power Supplies
Features/Benefits:
• Operates into a parallel tuned load
circuit for use with remote or existing
heat stations
• Multiple power/frequency combinations
for application matched performance
• Input power factor is 0.95 under all
operating conditions
• Output regulation of voltage, power or
current. Jumper selected
• Interchangeable control board
Factory calibrated to eliminate field
adjustment and calibration
• Modular, single-layer design for easy
access and maintenance
• Built-in annunciator panel for
simplified status/fault diagnostics
• < 85 dB operating sound level for
quiet operation
SP18 600 kW / 30 kHz
Transistorized Circuitry For
Improved Reliability
®
General Purpose Induction
Heating Power Supplies
®
STATIPOWER SP18 are water-cooled,
solid state power supplies designed
for case hardening, through hardening,
annealing, mass heating and many
other applications. Power supply
ratings are from 150 to 600 kW with
frequencies from 3 to 50 kHz in single
or dual frequency models.
See specifications on back.
All STATIPOWER SP18 systems
incorporate “Restart”circuitry
eliminating nuisance shutdowns
caused by voltage transients,
ground faults, shorted or arcing
loads. Because load current is not
used for commutation, equipment
can be operated with the output
shorted for easy trouble shooting.
Solid state accuracy assures output
power regulation of ±1% with a line
variance of up to ±10%. Reliability
is further enhanced by placement of
95% of all circuitry on one control
board which is accessible without
entering the high voltage section of
the power supply.
Reliable Design For Safety
And Long-Life Performance
®
STATIPOWER SP18 units have a DC
diode bridge, line choke and capacitor
bank to minimize the effects of line
noise and harmonic feedback. This
also insures a constant input power
factor of 0.95 regardless of loading for
the best possible efficiency, resulting
in lower electric demand charges. All
power components with DC potential
are electrically insulated from the
water cooling circuits. This eliminates
the possibility of electrolysis. Other
system features include an input line
disconnect with UVR, output isolation
transformer, differential pressure
switch and temperature switches on
water supply and return manifolds.
For more information, call 800/ 624-6297 or visit www.inductoheat.com