END FITTINGS0 pages
Revisiont
Datett
:1
: 04.04.14
PTFE ENCAPSULATED (ENCAP) END
FITTINGS
Loose BSPP Fixed Male Encap Fitting
and a standard, non-lined Ferrule
Swivel Flange Encap Fitting Crimped on
to Corroline+ Hose
Introduction
In response to requests from Customers who self-assemble Aflex Hose products, Aflex have developed a basic range
of PTFE encapsulated end fittings.
These can be used in place of standard non-lined end fittings to provide a PTFE lined alternative, without the need
to assemble and flare an Integral PTFE Lined end fitting.
Encap fittings do not provide the same advantages as Integral Lined fittings, namely the full hose bore size through
the fitting, and no internal entrapment areas.
Encap fittings do, however, provide a fully PTFE lined fitting with a flared face which is easier to assemble. Also, the
Aflex Encap fitting design has a significantly larger bore than the conventional PFA encapsulated fittings available
from other suppliers.
Construction and Application
Encap Fittings are assembled and crimped using the same non-lined ferrules, crimp diameters and assembly
procedures that are used with standard non-lined fittings, on all the Aflex PTFE hose product range.
Note: Corroline+ hose can be supplied with an alternative Direct Crimp (DC) fitting design, which is also available in
the Encap version, to special order.
The PTFE encapsulation is either natural or antistatic PTFE as required, with a PTFE wall thickness of 1.5mm (0.060”)
for sizes up to 11/2”, and 1.8mm (0.070”) for sizes 2” and above.
Important Note: The use of Encap fittings with hoses, ferrules or other components which are not all supplied by
Aflex Hose is strictly prohibited, and no liability will be accepted for any failures which result from such abuse.
The World’s Leading Manufacturer of PTFE Flexible Hose.
Spring Bank Industrial Estate, Watson Mill Lane, Sowerby Bridge, Halifax HX6 3BW
Telephone: +44 (0) 1422 317200 Fax:+44 (0) 1422 836000
Website: www.aflex-hose.com