Brochure de la gamme de produits Nuttall et Delroyd0 pages

A LT R A I N D U S T R I A L M O T I O N

Nuttall Gear and Delroyd

and manufacturing worm
gears and worm gear

Moduline® Integral Motors
by Nuttall

Available in ratings up to 40,000
HP and output speeds up to
20,000 RPM or higher in ratios up
to 9:1. Heavy cast iron or welded
steel housings for strength and
rigity.

Torque ratings up to 6,000,000
in.lb. and standard gear ratios
up to 1500:1. TDS and HPD
units incorporate precision
helical gearing in single, double,
triple, quadruple and quintuple
reductions.

Available in ratings from 1 to 200
HP and output speeds from 1.5 to
1430 RPM with AGMA Class I, II or III
service factors. Fits many applications
and provides total drive source
responsibility.

Custom Engineered Drivest
by Nuttall

Worm-Gear Setstt
by Delroyd

BX Conveyor Drive Unit Series
by Delroyd

Some of our most outstanding
products cannot be found
in a catalog because they
were designed for a specific
customer or application design.

The lowest cost and shortest
delivery schedules are normally
achieved through the use of
standard worm and gear sets.
Flanged rim design available for
mounting on any adaptable center.

Delroyd series BX Speed Reducers for
conveyor drives feature exceptionally
high overhung load capacity. This
design advantage usually permits
selection of a smaller drive unit for
a given load. Drywell construction
around the output shaft helps prevent
leakage from above.

Single Worm Reducer
by Delroyd

Double Worm Reducer
by Delroyd

Ratios 15:1 TO 355:1. Hardened,
and ground helical gears. Hollow
and solid output shafts. Vertical
and horizontal mountings. Fan
cooled is standard. Motor mounts
(C-Face adapters or scoops). Cast
iron or steel housings

experience in designing

Type TDS/HPD Parallel Shaft
Speed Reducer by Nuttall

Helical Worm Speed Reducer
by Delroyd

Worm Gear provide vast

SU/SD High Speed Gearst
by Nuttall

Ratios 5:1 to 70:1. Hollow & solid
output shafts. Vertical & horizontal
mounting. Fan cooled (standard).
Motor mounts (C-Face Adapters
or scoops). Cast iron or steel
housings

Ratios 75:1 – 4900:1. Right angle
and parallel shaft arrangements.
Hollow and solid output shafts.
Vertical and horizontal mounting.
Fan cooled is standard. Motor
mounts (C-Face Adapters or
scoops). Cast iron and steel
housings

drives as well as helical
drive assemblies for a
variety of mechanical
equipment. Our in house
test facility allows us to
expertly mount, align,
and couple your reducer
and motor. This allows
us to deliver a fully tested
and proven package that
will integrate into your
production system without
any worries or surprises.
Our mission is to provide
solutions.
Customer Service and
Application Support
800-432-0121

www.nuttallgear.com
www.delroyd.com
P-1723-16-C 6/12
Printed in USA

**This booklet is intended to be used for informational purposes only and does not extend any distributor authorization to
purchase products from
t
any Brand or Product beyond those listed in your authorized distributor agreement.