SEFCO F2 Pin safety clutches Adjustment guide0 pages
IN SAFETY CLUTCHES
FICHE TECHNIQUE >
nn77003 - 1 - 06/97 A nnDJUSTMENT
nnG nnUIDE
TECHNICAL DATA SHEET First, make sure that the piling up of the spring washers is according to the range of adjustment desired. >
nnSize 00 single or double piling-up
? Adjust the apparatus with a dynamometric key ? Tighten the nut with a HN 4 slotted key >
nnSizes 0 to 5 single or double piling-up Sizes 1 and 2 triple piling-up
? Insert the braking washer with spurs on the periphery ? Handtighten the adjustment nut until it touches the spring washers. Locate theslot on the nut which coincides with one of the engravings of the box. This is the
reference of the adjustment. ? Read in the table (see the verso) the number of divisions permitting to obtain thedesired torque. ? With the right spured spanned (see the following table), tighten the nut by thecorresponding value, then press down the spur facing the slot of the nut to ensure
the braking.Size012345 Spure spannedHN 7HN 8HN 11HN 13HN 16HN 18 ? For the size 0 apparatus, use a dynamometric key to have more precision in the setting off torque. >
Sizes 3 to 5 triple piling-up
nnB
? Read in the table (see overleaf) the dimensions A and B permitting to obtain thedesired torque. >
nnA
? Tighten the special nut to reach the dimension A ? Bring alternately and progressively the screws to the dimension B ? Tighten the lock nut >
nnSize 6 single or double piling-up
? Loosen all screws (1) (see schema) Nut (2) ? Read in the table the dimension X to obtain ? Tighten the nut (2) until obtaining the dimension X (see table overleaf) ? Tighten again alternately and progressively all peripheric screws (1) until hey areflushe with the face of the nut 8 screws (1) (2) >
nn