END-O-MAT press0 pages
Result : Identical product over the entire die area
Quick retooling and quick resetting to different sizes.
Capable of producing ends with dia. from 50 to 250mm ( 200 to 1000 ).
Maximum sheet width of 1200 mm ( 47” ).
High stroke speed up to 250 spm without idle stroke for sheets feeding and 275 spm
for coil feeding.
High stroke speed up to 250 spm without idle stroke for sheets feeding and 275 spm
for coil feeding.
Excellent material utilization thanks to minimal web width.
Sheet length measuring and compensating capability during operation.
No lubrication above product and die level.
No special foundation due to drive design which provides for balanced weight.
Low maintenance.
END-O-MAT press with 150 t
High speed press for stamping of ends and shells.
Press force 1500 kN.
Capable for operation two row tooling at up to
250 spm with CNC roller straight sheet feeder.
Capable for operation two row tooling at up to
275 spm with CNC roller coil feeder.
Result : Identical product over the entire die area
High speed press for stamping of ends and shells.
Press force 500 kN.
Capable for operation one row tooling at up to
230 spm with CNC zigzag sheet feeder.
The END-O-MAT stamping press is dened for sheet (zigzag and straight) and coil
processing (straight only). The maximum sheet dimensions are 1200 mm x 1200 mm
(straight) and 1100 x 1200 mm (zigzag); sizes which cover the entire range defined by
today's printing and lacquering lines.
The number of dies depends on the diameter, the available sheet width and the feeding
system and can reach between 2 dies (for diameter 153 mm and zigzag feeding and 16
dies (for end diameter 52 mm and straight feeding).
The speed of the stamping press depends on the diameter, too, and can reach up to 250
strokes/minute for end diameter 52, without idle stroke.
As already mentioned, the smallest possible web width to minimize scrap skeleton waste
is an essential prerequisite to save material costs.
Innovative features and advantages of the END-O-MAT stamping press
Bed and slide are of solid steel construction calculated for minimum deformation in the
tooling area, thus guaranteeing uniform product geometry for the entire tooling area.
Unlike conventional stamping presses, the END-O-MAT press is powered from below, this
means that the slide is positioned at the bottom and executes its strokes in an upward
direction. The main advantage of this den is the absence of lubricating points for guides,
gearwheels or bearings in or above the tooling area which prevents any soiling of the
29.03.2011
Page 1 of 2
"