Series RL rod lock0 pages

CATALOGUE > Release 8.6

MOVEMENT > Series RL rod lock

MOVEMENT

1

Rod Lock
Series RL
For cylinders ISO 6431/VDMA and ISO 6432
ø 20 - 25 - 32 - 40 - 50 - 63 - 80 - 100 - 125

»» Compact design
»» Functioning in both directions
»» Blocks without pressure
releases with pressure

The Series RL rod locks are available
in 9 different sizes (diameters: 20, 25,
32, 40, 50, 63, 80, 100 to 125 mm).
The compact dimensions allow units to
be fitted on cylinders where space is
limited.
Rod lock units are often used to hold
the load in position during Emergency
Stop conditions or when the air supply
may be accidently disconnected from
the system. The holding forces are
measured at 8 bar and apply in both
directions.

Caution!
The rod lock should not be used to
“brake” the piston rod in dynamic
conditions and must only be applied
when movement has ceased.
Note:
the cylinder piston rod length must be
increased when using a rod lock unit.
See the table for the minimum extension
lengths for each diameter.

GENERAL DATA
Type of construction

compact

Operation

piston operated clamp

Materials

housing: anodized AL
clamp: brass
seals: NBR

Cylinder diameter

ø 20 - 25 - 32 - 40 - 50 - 63 - 80 - 100 - 125

Operating temperature 0°C ÷ 80°C (with dry air -20°C)
Configuration

pressure release

Operating pressure

3 ÷ 8 bar

Ports

M5 = ø20, 25, 32 - G1/8 = ø40, 50, 63, 80, 100, 125

Fluid

Filtered air without lubrication. If lubricated air is used, it is recommended to use ISOVG32 oil. Once applied the lubrication should
never be interrupted.

1/10.10.01

Products designed for industrial applications.
General terms and conditions for sale are available on www.camozzi.com.