YSI P 700 Orthophosphate Analyzer0 pages

SPECIFICATIONS

ttt DOCUMENT #W105-02

YSI P 700 IQ Orthophosphate Analyzer
Orthophosphate Measurement for the
IQ SensorNet System
The P 700 for orthophosphate measurement can be used as
a stand alone analyzer or networked with other sensors in an
IQ SensorNet 2020 XT network. Use the P 700 throughout the
wastewater plant from pre-sedimentation to biological tanks
to the effluent. The P 700 provides continuous data to help
operational efficiency improvement decisions and phosphate
elimination verification.

Parameters:

•tCompact design - pump for permeate supply is integrated

in the analyzer housing

Orthophosphate

Applications:

• Simple system configuration with the IQ SensorNet;

measure additional parameters in addition to
orthophosphate

Wastewater treatment (municipal and industrial); presedimentation, aeration, post-sedimentation, effluent

• Low reagent consumption - exchange solutions on

average every 4-8 months, reduces overall cost vs. other
analyzers

• Automatic or manual calibration (adjustable)
• Automatic cleaning function (adjustable)
• Uses proven Vanadomolybdate (yellow) method of

detection

• Wide measuring range - two measuring ranges allow the
The P 700 filter mounted inside a
tank. Easy to clean with water and a
brush, bleach, or hydrochloric acid.

P 700 to be used in a wide range of locations throughout
the WWTP

• Indoor or outdoor versions available with heating or

cooling

Technical Information for Filtration
Membrane Surface Area

155.00 in2 (1.00 cm2)

Max. Operating Temp.

113ºF (45ºC)

Max. Operating Over Pressure

(Raw water to permeate side): 2.0 bar at 68ºF (20ºC)

Operating Under Pressure
(permeate side)

Approximately 0.5 bar at 68ºF (20ºC)

Materials

Housing: PVC; Seals: NBR; Screws: Stainless Steel

YSI.com/PO4