quick load liner autolength system0 pages

QUICK LOAD " LINER

AUTDLENGTH SYSTEM

The QUICK LOAD™ Liner Auto Length"'1 System

from Tregaskiss is designed to minimize down-

time, wire feeding and quality issues commonly

associated with the liner being cut to an incorrect

length.

Short liners are a common root cause of poor wire

feeding. Further, a short liner does not have a

chance of properly seating in the retaining head -

often resulting in "bird-nesting" of the

welding wire, or premature contact tip

failure and wear. FULLY EXTENDED SPRING

Wire feeding challenges reduce efficiency /_ —■\

of the welding process and cause ^^^www^r"

undesireable (and expensive) i * *

downtime. A system upgrade to

this new innovative product can

help improve welding efficiency ''~- ^rrr^-"-'; ^aBli*

and reduce costly downtime.

FULLY COMPRESSED SPRINC

IN AUTOLENGTH PIN

HOW IT WORKS:

Housed inside the power pin, this spring-loaded module applies constant forward

pressure on the liner. This ensures that the liner remains seated properly inside the

retaining head and also allows for up to one-inch forgiveness if the liner is cut too short.

SPRINC

PIN

NEW TECHNOLOGY

Spring-loaded module applies

constant forward pressure on the

liner, keeping it seated properly

in the retaining head

Allows for up to one-inch

(2.54 cm) forgiveness if the

iner is cut too short

Accommodates liner movement

during welding

INCREASED PRODUCTIVITY

• Reduces issues caused by the

iner being cut to an incorrect

length

• Decreases burn-backs caused

oy misalignment between the

iner and contact tip

• Improves wire feedability by

enhancing wire alignment

with the contact tip

DESIGNED SPECIFICALLY

FOR USE WITH

QUICK LOAD™ LINERS

• Requires less than 1/2 the time

and effort to replace (compared

to conventional liners)

• Liner portion feeds from the

front - No need to cut and

waste wire!

• Available for Tregaskiss TOUGH

GUN1" Robotic MIG Guns and

Bernard™ T-Guniu Series Semi-

Automatic MIG Guns