Pumping centre, OS-20000 pages
Pumping centre, OS-2000
for SKF MonoFlex, single-line lubrication systems
5
1
3
5
2
9
6
8
The pumping centre OS-2000 is designed
for cyclic lubrication of oil-lubricated chains,
quides, sliding surfaces and bearings. The
system provides significant wear reduction
for machines and their components, thus
playing a decisive role in the minimization of
production downtime.
Application
1t Control center series ST-1100i,
1240, 1340 or 1440
2t Pumping centre, series OS-2000
3t Main supply line
4t Dosing module series B-dosers,
OS-3-Zn or OS-4-Zn
5t Lubrication linet
6t Lubrication brushes
7
7t Sliding surface nozzle
8t Spray nozzle
9t Remote-controlled shut-off valve
The system functions as follows:
The control center starts the pump, whereby the pressurized lubricant is forced along
the headers to the dosing modules. From
the dosing units, the lubricating oil is applied
to the lubrication point by either direct dripping and/or by using different types of oil accessories such as lubricating brushes, spray
and sliding surface nozzles featuring optimum tribological design. Check valves
located in the lubrication center prevent oil
drainage from the piping even during prolonged shutdown.
®tSKF is a registered trademark of the SKF Group.
©tSKF Group 2013
The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permission is granted. Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be
accepted for any loss or damage whether direct, indirect or consequential arising out of the use of the information contained herein.
PUB LS/P2 11085/2 EN · January 2013