EM1206 BASIC-programmable Ethernet Module0 pages

....................................................................................................................................................................................................
.................................... ............................................ ............................................ ........................................
continued on next page
Features
10/100BaseT Ethernet port
Flash disk and RTC onboard
Four serial ports; up to 17 I/O lines
Supports Wi-Fi, LCD, keypad, buzzer
Mates with RJ203 jack/magnetics
Very compact (33.2x18.1x5.5mm)
About
The EM1206 is a miniature BASIC-programmable embedded module. In combination with the RJ203
jack/magnetics, the EM1206 occupies only 34.5x19 mm of board space. Alternatively, the EM1206 can be used
with any suitable magnetics and jack.
The module’s hardware mix, which includes 100Base/T Ethernet, four serial ports, fl ash disk, EEPROM, and RTC,
has been carefully tailored to address the typical needs of network-enabled control applications.
This makes the EM1206 especially suitable for “connected” edge products such as sensors, network-enabled card
readers, actuators, and other lightweight devices.
The EM1206 can also support Wi-Fi communications (this requires GA1000 add-on board), as well as external
LCD, keypad, and buzzer.
The EM1206 can be ordered standalone or in combination with the RJ203 module.
Not available in the U.S.
Specifications
Based on a high-performance purpose-built
88-MHz ASIC (T1000).
10/100BaseT auto-MDIX Ethernet port
(no magnetics).
Four high-speed serial ports (CMOS-level):
Baudrates of up to 921,600bps;
None/even/odd/mark/space parity modes;
7/8 bits/character modes;
Full-duplex mode with optional fl ow control;
Half-duplex mode with direction control;
Encoding and decoding of Wiegand and clock/
data streams.
Up to 1024KB fl ash memory for fi rmware,
application, and data.
2KB EEPROM for data storage.
RTC with backup power input.
Supports external LCD and keypad.
Programmable square-wave output for external
buzzer.
Up to 17 general-purpose I/O lines (including 8
interrupt lines).
Control lines for two external status LEDs.