NSC-M Series Controller0 pages
NSC-M Series
The NSC-M Series motion controllers are designed
for use with all Newmark stepper motor systems. The
controller can communicate with the host computer
through an RS-232 interface. It can manage up to four
axes and perform coordinated or independent motion
of each or all the axes simultaneously. With built-in
high level functionality, such as circular and linear
interpolation, multi-tasking and custom profiling,
programming the controller is greatly simplified.
Voltage Input | 85-260 VAC |
OutputCurrent | Up to 2 Amps Peak |
Motor Type | 2/4 Phase bipolar stepper |
Microstep Resolution | Up to 51200 steps per rev. (1.8° motor) |
Communications | RS-232, 300 to 38.4kbps |
Program and Data Storage | Flash |
Number of I/O | 8 (Software configurable as input or output) |
Encoder Feedback (optional) | High-Speed Differential Inputs |
Encoder Functions | Stall Detection and Position Maintenance |
" OM5-EZ(tm) Win32 Terminal
File Terminal Help
Terminal | Cmd Script |
{Attempting to contact OMS device___}
(Connecting to PCS3 (RS-232) on C0H1)
(Handle acquired for 'PC68 (RS-232)'}
The motion controller can operate
as a stand-alone system through
the RS-232 port. It utilizes a 32-
bit microprocessor to control the
trajectory profile, acceleration,
velocity, deceleration and direction
of selected axes.
Our multi-axes controller is
commanded using virtually any
programming language to pass
simple ASCII command strings to
the controller through the RS-232
port.
Program Sample
This program will move the motor 34,000 steps back and forth until
the stop(ST) command is executed.
AX
AC100000
VL25000
WH
MR34000 GO
MR-34000 GO
WG
* address the X axis
* set acceleration to 100,000 steps/sec2
* set velocity to 25,000 steps/sec
* start of loop for repetitive motion
* move relative +34,000 steps
* move relative -34,000 steps
* loop back to starting WH command
The terminal software is an easy to setup and use
interface for NSC-M programming.
Model Description
NSC-M2 Two Axes Stepper Motor Controller
NSC-M2-E Two Axes Stepper Motor Controller with Encoder Feedback
NSC-M3 Three Axes Stepper Motor Controller
NSC-M4 Four Axes Stepper Motor Controller
Ordering Information
"