Voltage Integrated Source0 pages
MeterTest
VIS Voltage Integrated Source
ISO 9001:2000
Features:
Broad range of output voltages
Broad range of allowable loads
High accuracy and stability
Low harmonic distortion
Multilevel protection system
Integrated Digital Signal Generator
Generation of harmonics
The VIS Voltage Integrated Source is a
single-phase alternating voltage source, designed
for use in electricity meter testing systems and in
laboratories. The output voltage is isolated and
independent of mains voltage.
The power stage of the source utilizes the
Power Width Modulation (PWM) technology,
which ensures high efficiency and thus contributes
very small heat losses. The stage is driven by an
onboard Digital Signal Generator. The control
signal may be composed of harmonics of
independently defined amplitudes and phases. The
internal feedback loop utilizes the DSP technology.
Advanced algorithms applied ensure high stability
of amplitude and phase angle as well as low
distortions of the output voltage over a full range of
allowable loads of various characters.
A multilevel protection system implemented
protects the source against overload, short circuit,
overheat and makes operation of the device reliable
and safe.
The VIS device is equipped with an isolated
serial interface and can be operated by a PC or
other controlling device (host). A number of
sources can be synchronized and operated together
to form a poly-phase system. The communication
protocol is provided to control output settings as
well as to access all internal registers.
The VIS Voltage Integrated Source is
accommodated in a 19 inch plug-in case.
VIS-400
Technology of the power stage
Output voltage range (Phase-Neutral)
VIS-1200
VIS-2600
PWM with digital feedback loop
*
30 ÷ 350 V
*
400 VA
Output power for linear loads
Output voltage stability
1200 VA
2600 VA
<< 0.005% (integration time 150 s)
Total Harmonic Distortion (THD)
< 0.3%
> 85%
Efficiency of the power stage
*
Frequency of the fundamental component
**
45 Hz ÷ 65 Hz
Phase angle
0° ÷ 360°
Harmonics
user programmable
isolated RS422/RS232
Control
Dimensions (H x W x D)
170 x 440 x 600 mm
300x440x600mm
Dimensions (H x W x D) with front panel and
rear connectors
174 x 484 x 750 mm
307x484x750mm
*)
other values available on request
for poly phase systems
**)
MeterTest
MeterTest Ltd., Armii Krajowej 7, 58-100 Swidnica, POLAND
www.meter-test-equipment.com
Phone/Fax: +48 74 856 63 92, E-mail: office@metertest.eu
www.metertest.eu
Having in mind the care about continuous improvement of the product operational qualities, the producer reserves the right to introduce possible modifications in the
construction and workmanship. That is why some of the dimensions, drawings, parameters or descriptions may differ from these shown in this catalogue.
Doc #3202.042.004-EN