CenterScan0 pages
Non-Contact, Eccentricity Measurement System
BETA LaserMike CenterScan 2010
for Wire & Cable Production
t Non-contact gauge
t Multi-function: eccentricity, diameter
and flaw detection
t Ultra accurate, low-drift measurements
t High-speed signal processing for
precise measurements on stranded
products
t Compact design for wider range of
gauge installation on production line
t Robust electronics with superior noise
immunity allows closer placement to
line devices
t Factory calibrated for fast, easy setup
and simple recompensation
t Accurate product positioning with
minimal alignment
t Rugged construction for reliable
operation under the harshest conditions
t Flexible communication for easy
integration, data management
t Optional ultra-bright integrated display
and operator interface for ease of use
Wire and cable manufacturers now have
better quality control
When the core of insulated wire and cable moves off-center,
your product quality suffers. And with the increasingly tighter
tolerances demanded by users, unchecked wire or cable
eccentricity can leave you with reels of unusable product.
There’s now a proven solution to help you dramatically control
and improve the quality of your product while reducing material
consumption and scrap, increasing productivity, and maximizing
your profits.
The Beta LaserMike CenterScan 2010 measurement system
accurately and reliably monitors the diameter of insulated wire
and cable and eccentricity of conductors during extrusion and
insulation processes. This intelligent gauge never touches your
product and can measure diameters from 0.1–10 mm
(0.004 – .40 in) and determine eccentricity and diameter with
±0.0005 mm (±0.000020 in) accuracy. Also, CenterScan’s
high-speed measurement capabilities enable you to run higher
line speeds and produce more finished wire and cable in less
time while maintaining the highest level of product quality.