FIDAMAT 60 pages

© Siemens AG 2015

Continuous Gas Analyzers, extractive
FIDAMAT 6
General information

■ Overview

■ Application
Areas of application
• Environmental protection
• Wastewater (in conjunction with a stripping device, verification
of the hydrocarbon content of liquids)
• TLV (Threshold Limit Value) monitoring at places of work
• Quality monitoring
• Process exhaust monitoring
• Ultra-pure gas measurements in media such as O2, CO2,
inert gases and cold sample gases
• Measurement of corrosive and condensing gases
• Process optimization

The FIDAMAT 6 gas analyzer is suitable for the determination of
the total hydrocarbon content in the air and high-boiling gas mixtures.

■ Benefits
The FIDAMAT 6 gas analyzer is distinguished by its wide range
of applications:
• In the presence of up to 100 % H2O vapor
• In ultra-pure gas applications
• With high-boiling components (up to 200 °C)
• In the presence of corrosive gases (with preliminary filter).
The FIDAMAT 6 exhibits:
• Extremely low cross-sensitivity to interfering gases
• Low consumption of combustion air
• Low influence of oxygen on measured value
The analyzer is additionally equipped with warning and fault
messages:
• For failure of combustion gas
• If the flame is extinguished
• To indicate pump and filter faults

Further applications
• Chemical plants
• Gas manufacturers (ultra-pure gas monitoring)
• Research and development
• Cement industry (measurement of emissions)
• Paint shops and dry-cleaning systems
• Refineries (tank farms, wastewater)
• Drying systems
• Solvent recovery systems
• Pharmaceutical industry
• Automotive industry (engine development, engine and transmission development and certification)
Special applications
Special applications
Special applications are available on request in addition to the
standard combinations, e.g. measuring range 0 to 100 %.
TÜV version
Measurement of flue gases according to 13th BlmSchV/17th
BlmSchV and TA Luft for oil, coal, gas, and waste as fuels.
Furthermore, the TÜV-approved versions of the FIDAMAT 6 comply with the requirements of EN 14956 and QAL 1 according to
EN 14181. Conformity of the analyzers with both standards is
TÜV-certified.
Determination of the analyzer drift according to EN 14181
(QAL 3) can be carried out manually or also with a PC using the
SIPROM GA maintenance and servicing software. In addition,
selected manufacturers of emission evaluation computers offer
the possibility for downloading the drift data via the analyzer’s
serial interface and to automatically record and process it in the
evaluation computer.

Siemens AP 01 · 2015

1/217

1