Type SCH16G0 pages
Automation /
Micro
Type SCH16G
Hollow Shaft Encoder -
Hollow Bore:
Resolution up to 5000 ppr
Standard IP 50
Max. 5.000 rpm
Ø2
Ø
16 mm
mm and Ø 3 mm
Mechanical Specifications
Electrical Specifications
Material:
Housing:
Aluminum / Brass
Cap:
Aluminum
Hollow Shaft: Brass
Weight:
Encoder: ~ 12 gr (0,53 oz)
Cable: 50 gr / meter (1,76 oz / meter)
Bearing Life:
Code:
> 1,9 x 1010 revolutions at rated load
Bearing Pre-Load:
1 to 3.600 ppr
4.000 to 5.000 ppr
Shaft Speed:
5.000 rpm (max.)
Starting Torque:
< 0,005 Nm (0,708 oz-in) at 25° C
Mass Moment of
Inertia:
0,25 gcm² (3,54 x 10-6 oz-in-sec²)
Hollow Shaft
Loads:
Axial: 10 N (2,25 lbs) max.
Radial: 10 N (2,25 lbs) max.
Incremental
Resolution:
100 to 5.000 ppr (pulses per
revolution)
Supply Voltage:
4,5 Vdc min. to 30 Vdc max.
(35 mA max. - no load)
**
Output Voltage:
Low: 500 mV max. at 10 mA
High: (Vin – 0,6) at -10 mA
(Vin – 1,3) at -25 mA
**
Output Current:
20 mA max. load
per output channel
Frequency Response:
200 kHz max.
**
Output Format:
Two channel (A, B) quadrature
with Index (Z) and optional
complementary (A-, B-, Z-)
outputs
Phase Sense:
A leads B clockwise (CW) from
the mounting end of the encoder
Environmental Specifications
Operating Temp.:
-20° to +70° C
Index:
Gated with Channels A and B high
Storage Temp.:
-20° to +85° C
Shock:
100 G / 11 ms
Accuracy:
+/- 26 arc-sec.
Vibration:
10-2000 Hz / 10 G
Outputs:
ASIC
Bump:
10 G / 16 ms (1000 x 3 axis)
Humidity:
98 % RH without condensation
Enclosure Rating:
IP 50 / Nema 5 (approx.)
Electrical Protection:
Noise Immunity:
Differential or Inverted
Reverse polarity and output short
circuit protected
Tested to EN61000-6-2 : 2005
(industrial environments)
Electromagnetic compatibility
(EMC) and EN 61000-6-3 : 2007
(residential, commercial, and lightindustrial environments) for
Electromagnetic compatibility
(EMC)
2 (N)
7 (N)
Connection Options
Cable:
8 leads (0,05 mm2, 30 AWG)
twisted pairs; shielded
Flat Cable:
10 lead flat cable with IDC connector
**
= It is recommended, not to combine max. Value for all 3 parameters
Rev. 1.5 21. January-2014
Scancon Tranevang 1 3450 Allerød Denmark
Tlf +45 48 17 27 02 Fax +45 48 17 22 84 www.scancon.dk
p. 1
"