APC 20000 pages

SMART PRESSURE TRANSMITTER
APCE-2000
üm A output signal + HART protocol
4…20

ü
Rangeability 100:1

üIntrinsic safety
ATEX

ü
Gold plated diaphragm (Au)

ü
Accuracy 0.1%
Application
The APCE-2000 pressure transmitter is applicable to the measurement of the pressure, underpressure or absolute pressure
of gases, vapours and liquids. The active sensing element is a piezoresistant silicon sensor separated from the medium by
a diaphragm and by specially selected type of manometric liquid.

APCE-2000PD

PD version

APCE-2000PZ

PZ version
Version designed to work in hard
conditions:

Economical version:
- housing 304ss
- protection IP65
- electrical connection DIN 43650
- the electronics encased in
a protective silicon gel
- ATEX Intrinsic safety

- housing material: 304SS / 316SS
- protection IP66
- the electronics encased
in a protective silicon gel
- cup with knurled handgrip
- ATEX Intrinsic safety

II 1/2G
Exia IIC T4/T5/T6 Ga/Gb
I M1 Ex ia I Ma
II 1D Ex ia IIIC T110C Da

SW27

2 8

SW27

5

G1/4’’

Æ
4
Æ
25

G1/2 type
G1/2", Æ
4 hole
M type
M20×1.5, Æ
4 hole

SW27

15

20

15

8

8

SW27

2 8

SW27

II 1/2G
Exia IIC T4/T5/T6 Ga/Gb
I M1 Ex ia I Ma
II 1D Ex ia IIIC T110C Da

Æ
12

1/2’’NPT

Æ
25

1/2’’NPT type
1/2’’NPT male +
internal thread G1/4’’

Æ
25

G1/4’’

GP type
G1/2", Æ
12 hole
P type
M20×1.5, Æ
12 hole

SW41

1/2’’NPT F type
internal thread 1/2-14NPT

SW27

SW32

O-ring
26 × 2

Æ
30

20.5
Æ
25
Æ
35

CG1 type
G1" with flush diaphragm

CM30×2 type
M30×2 with flush diaphragm

O-ring
15×2

10

10

15

31

2 10

10.5

SW27

Æ
18
G1/2B

CG1/2 type
G1/2" with flush diaphragm

Version with direct or remout mount
diaphragm seal.
Diaphragm seal data -see chapter III

Communication and configuration
The communication standard for data interchange with the transmitter is the HART protocol.
Communication with the transmitter is carried out with:
a
a KAP-03 communicator,
a other Hart type communicators,
some
a using an HART/USB/Bluetooth converter and RAP ORT 2
a PC
configuration software.
The data interc hange with the transmitter enables the users to:
a the transmitter;
identify

a
configure the output parameters:
– measurement units and the values of the start points and
end points at the measurement range;
– damping time constant;
– conversion characteristic (inversion, user’s non-linear
characteristic);
athe currently measured pressure value of the output
read
current and the percentage output control level;
aan output current with a s et value;
force
a the transmitter in relation to a model pressure.
calibrate

I/ 7