AirForce 500i0 pages

AirForce 500i
®

244395
Feb. 2013

115/230V Portable Air Plasma Cutter
115/230 Volt

eed to cut steel? Thinking about an oxy acetylene
cutting torch to do the job? Consider a plasma
cutter. This simple technology uses an electrical arc
and compressed air to cut steel, aluminum, and
other conductive metals.

N

The AirForce 500i is powered by standard
household voltage (115 or 230 VAC) using the MVP™
(multi-voltage plug) which allows no-tool voltage
changes. It excels at cutting sheet metal and
3/8-inch mild steel, and can even sever 5/8-inch
mild steel. The MVP plug and lightweight inverter
power supply make this plasma cutter the most
convenient, portable system available with a larger
cutting capacity.

#500548
Includes:
16.5-ft. (5 m) HP-50 hand-held torch
16.5-ft. (5 m) work cable with clamp
Extra consumables (2 electrodes, 2 tips and 1 air fitting)
10-ft. (3 m) power cord with 5-15P (115 V, 15 A) and 6-50P
(230 V, 50 A) MVP plugs
Easy-to-connect, built-in gas/air filter and regulator for
extra protection

Compared to the complexities of an oxy fuel cutting
torch system, plasma cutting is easy:
Cuts faster than oxy fuel
More precise cut, thinner kerf, less slag to clean up
Smaller heat-affected zone for less warping
No gas pressure settings or flame tuning needed
No preheating of metal prior to cutting

Features

Benefits

Dual-voltage capability with
MVP™ (Multi-Voltage Plug)

Allows you to connect to common 115 or 230 V power receptacles without the use of any tools — simply choose the
plug that fits the receptacle.

HP-50 torch

Designed for increased comfort with an ergonomic trigger safety, more efficient cooling and economical replacement
cutting tips.

Wind Tunnel Technology™

Prevents abrasive dust and particles from damaging internal components.

Fan-On-Demand™

Cooling system operates only when needed reducing power consumption and contaminants drawn into the machine.

Power factor correction (PFC) circuitry

Draws up to 30% less amperage for the same cutting range as compared to the competition. PFC expands operators
work area via extension cord, while minimizing nuisance circuit breaker trips caused by voltage drops.

LVC™ line voltage compensation

Provides peak performance power under variable input voltage conditions (±15%) for steady and cleaner-ending cuts.

Internal gas/air filter and regulator

Controls amount of usage and flow of air or gas.

Starts without high frequency

Protects unit by not interfering with or damaging controls or computers.

Diagnostic lights

LED lights for quick troubleshooting of pressure, power and cup situations.

Cable management strap

Secures torch, work cable and power cord to make transporting easy and convenient.

Postflow cooling circuit

Extends life of consumables and torch by cooling them with postflow air after trigger is released.

Compatible with engine-driven welders

Complete cutting capability when powered by an engine-driven welder with a 240 V generator power outlet of
6 kW or more.

Hobart’s 5/3/1 Industrial Warranty

Five-year warranty on transformers, stabilizers and generators; three years on electronics (drive motors, rectifiers);
and one year on guns (MIG and plasma torches).