ECO Saw Blade0 pages
Grinding Manual
ECO Saw Blade (T.C.T. Saw Blade)
A New Dimension of Performance
Date: April 13, 2007
Number of pages: 1
Top grinding
Grinding Wheel: SDC 200/600 N 100 DT 15-7.2
Wheel feed speed 1.2 mm/sec.
Stock removal 0.1-0.3 mm
Face grinding
Grinding Wheel:
SDC 140 N 125 BA41
(drill type, 6 mm diameter)
1.0 mm/sec.
0.1-0.2 mm
Wheel feed speed:
Stock removal:
Top View
Tooth
Wheel
H
Flat tooth
Inverted
V tooth
Flat tooth
Inverted
V tooth
A
A
Flat tooth
For best performance we recommend to
alternate the direction of rotation of the grinding
wheel at for the flat teeth
The difference H shown in the figure
above should not exceed 0.05mm
The difference in of the angle A
should not exceed 2 degrees.
General Comments and Recommendations
Wet grinding, oil or water, is self-evident
Make sure not to change the tooth angles (angles are mentioned on our saw blade and box)
Make sure to remove all wear, only a sharp edge delivers a good cut quality and long edge life
Make sure to recess the gullet area and the back of the tooth
Interpretation of grinding wheel specifications can be found at www.asahi.co.jp or contact Kanefusa
For further information, please contact Kanefusa or a dealer in your area. All contact addresses are
listed on our website or email to our Headquarter at sales-ex@kanefusa.co.jp
Kanefusa Corporation
Ohguchi-Cho, Niwa-Gun
Aichi-Ken, 4800192, Japan
Phone: +81(0)587-95-7221
Fax:+81(0)587-95-7221
Email: sales-ex@kanefusa.co.jp
©Kanefusa Corporation
©Kanefusa Corporation
www.kanefusa.net
www.kanefusa.net