INTG1 Series Circulation Pumps0 pages

INTG1 Series
A GORMAN-RUPP COMPANY

p r e s e n t s
16.00 

Max. Fluid Temp: 203°F (95°C)
Max Sys. Pressure: 75 psi

Flow and pressure dependent on
input voltage

Materials in contact with
solution
Body: PPS (Ryton®)
Impeller: PPS (Ryton®)
Pump Shaft: Ceramic
Bearing Plate: PPS (Ryton®)
Housing: PPS (Ryton®)

TOTAL HEAD (Feet) 

FLOW RATES: H2O

6.06 

12.00 

Ports: 1/2” MHB, 3/8” MPT

Max Head: 13.00 FT, 5.63 PSI

7.576.93 

14.00 

Weight: 10 oz (283.5 grams)

Max Flow: 1.96 GPM, 7.15 LPM

CAPACITY (Liters Per Minute) 
5.67
1.89 
3.78 

5.20 

10.00 

4.33 

8.00 

3.46 

6.00 

2.60 

4.00 

1.73 

2.00 

0.86 

0.00 

Rotor Shell: PPS (Ryton®)

0.00 

Static O-Ring: EPDM, FKM (Viton)

Motor specifications
Motor: Integrated, Brushless DC
Supply Voltage: 12v BLDC or 24v BLDC w/ 0-5v third wire speed

control (optional)
Inrush Current: None. Ramps up to running current.

0.50 
1.00 
1.50 
CAPACITY (Gallons Per Minute) 

TOTAL HEAD (PSI) 

Specifications

2.00 

The above curve is an all inclusive overview of the INTG1 Series catalog models represented on this tech sheet. Gorman-Rupp Industries
designs and manufactures pumps and pumping solutions for the Original Equipment Manufacturer (OEM). All models shown can be configured to meet specific OEM application requirements. Contact GRI for
design points that fall outside of shown parameters.

It is recommended that the customer provide circuit over current
protection to the pump. 5 amp fast acting fuse is recommended.
Electronics Max Power: 18 watts.
Remote Speed Control (Optional - Consult Factory)
•t Third Wire
•t 0-5 volts (Reference DC NEG). Speed is controlled by a nominal
0-5 volt DC signal.

Mounting Base
Variable 360° rotation
Note: Testing performed in a controlled laboratory environment. Actual performance may vary (+) or (-) 10% from the information shown.

180 Hines Ave. • Bellville, OH 44813 • PH: 419-886-3001 • FAX: 419-886-2338 • www.GRIpumps.com
GRI INTG1_INTG3_INTG7 Specifications_032315

032315

Page 2